6G Celicas Forums

So how much do you want for the whole car?

Another ride in your ride? Nice!

I have a 00' GT 1ZZ whereabouts do you live? If you're close I might hire you to fix mine.

It's NOT a 6gc lol

Perhaps I should have posted it in the what makes you laugh thread lol.

H1gher Reflex of course

HA! Honda driver moment.

Shopping around for some race seats and I was wondering what you guys would recommend as far as brand and comfort.

Part of me wants to go with sparco just for the name, but then again other than Corbeau and Vulture I'm not too familiar with any other brands.

Recommendations?

Who is Piro? lol I thought this was supposed to be Conan.

I saw this and died laughing. Note: I'm NOT racist, but this is just too funny.

I have hardly any room to work when I'm under it. After about an hour of trying to loosen the bolt on the solenoid with one hand I'm half tempted to take the exhaust off just to have it out of my way.

Any easier way of doing this?

I'm trying to replace my + battery cable on a 97 ST and I traced the cable back to the starter before it ran out of sight and I couldn't reach any further. Problem is it's behind the engine and I can't figure out if I should try to get to it from up top or jack the car up and go at it from the bottom. Both ways seem pretty cluttered to me. Any suggestions?

You wouldn't happen to know how tight it should be upon replacing the belt would you?

Go ahead and make one. I'm not too familiar with wiring period.

In regard to everyone here who has taken the door panels off and installed 8" aftermarket speakers.

What brand are you using, and what do you think sounds best in your 6th gen?

Hey guys, I recently bought an aftermarket head piece for the sole purpose of hooking my iPhone up to it and listen to all my music through that. It proved to be a big hassle, and I discovered that the Alpine IDA-x100 was made for iPods and such exclusively. I was wondering if I could get any info on what I would need, or if there's even a mount for this piece for a 6th gen out there before I go off and purchase it for nothing.

EDIT: My main problem is the head mount. I can't find one for a 6th gen anywhere. I've already got a wire harness.

Never mind guys, I found the how-to guide. Took me a minute to find it. This can be deleted.

I'll check all that out. How tight should the belt be on?

This has been happening for awhile now. Initially I had a bad serpentine belt and replaced it. The sound stopped for awhile but eventually came back. Now I have no idea what is causing the sound. I added power steering fluid and that worked to a degree but now that doesn't have any affect at all. The sound seems to stop once I either hit a certain amount of RPM's or once the car has been in motion for awhile. I was wondering if anyone could give me some answers. Here is a vid for further examination.

http://www.youtube.com/watch?v=ZH2lpxHPv48

Actually no I couldn't find the night shades lol. I found a substitute but it's been so long I can't remember what it was. They work just the same though.

I'll check that out

I may or may not show up. My car is in pretty bad condition. Needs a new tension pulley and body work among other things. But I'll see.

Hmm...that's a rim per pay check lmao.

That just looks horrible...

Thanks a lot . Should I just spray paint the whole car? lol

EDIT: DUH! I did the license plate panel as well. Forgot to mention that part.