6G Celicas Forums

Looking to get a GT4 upper grille insert to add to my stock gt bumper. Thank you.

That should work great! Thanks!!! About how far up the bend in the bumper does it start? 1" maybe?

Looking to cut a grille into my bumper. If anyone is able, or willing, to provide some measurements from their GT4 grille that would be wonderful! Thank you.

Kind of what I was thinking as well. Thanks. Id appreciate the measurements if anyone is willing to supply them!

Wondering if many have cut an upper grille into their bumper between the high beams? I've found one member here who's done it. Any advice on doing it? Like how to make the cuts nice/straight? Thinking maybe only a small one like the Lexus SC300 from mid/late 90's. Or even approximately a GT4 size. I have the bumper off the car to get it repainted and would like to cut the opening before its painted. Advice from anyone who does custom body work... I don't know how to lay fiberglass, so it'll probably endup as just an opening or maybe mesh behind it. Thank you.

I think lagos's car looks nice. I just bought a set of tires for the Tc rims I have, 225/45/17... price was right. SO do you think 15mm spacers all around is best or is that just spacing the rear? Thanks!

Cool. Sadly I'm still not totally understanding it. Offset and backspacing are things I don't understand fully. I guess I might just put sOme tires on the rims, put um on the car and measure.

Thanks for help.

Will it be close to the strut if I have a spacer/adaptor installed. That'll push it away from the strut also, correct? Then I just don't know about making contact with the fender itself.

I know I read a thread on here where someone said to get 225/45/17 on the scion rims and you'd be happy you did. I just don't know what other mods he was running.(lowering and spacers)

45mm offset.

I'm looking to lower it just purely for style. Most things on this car will be about looks. It's not going to be auto crossed or anything like that. Just a nice looking little car to toodle around in. Like my version of a 70 year olds corvette. Just want to know the right way to setup the scion rims to look nice fitting and get best ride I can. Tire size being stock is not a concern. And with the knowledge base here I'm sure I can achieve this in a more cost effective manner than trial and error.

Main thought is I don't want to be rubbing inside fender wells and ruining panels or tires. The eibachs drop it 1.5" and I put spacers on to give it a nicer stance, what size rubber would be advisable with what size spacers? Thanks to all.

I Picked up a set of TC rims for ultra cheap to go on my 95 gt. I want to lower it with an eibach kit and was wondering a few things: spacers(sizes), tires(size), and shock choice.

I've read that 225/45/17 are recommended. Is that at stock ride height or would that work lowered too?

38mm spacer for rear brings it to 7mm. That too far? Should I get the 25mm? I like hellaflush style, but not necissary.
And 15mm for front? Im not sure. Getting rear fenders rolled, I gathered that much.

Lastly, what shock is recommended to use with the lowering springs?

I appreciate all help and input. Thank you.

Need drivers front fender... Condition? Price? Shipped to 55733

Just got a set of TC rims for my celica and see someone recommends 225/45 tires. Want to do an eibach sport drop, what size spacer do I need w the drop to make the car look nice? Hella flush not necessary. Thanks for the help!!

Skirts sell yet? Thanks!

I'm looking for side skirts...?