6G Celicas Forums

Welcome Guest ( Log In | Register )


Feb 11, 2016 - 8:13 PM Forum: Engine/Transmission/Maintenance · Post Preview: #1078724 · Replies: 2 · Views: 440
AwesomeRob

Enthusiast

Joined Sep 6, '12
From Eugene, OR
Currently Offline


My girl and my car decided enough was enough two weeks ago. I'm sad about the girl but its gonna be hard to get over it without my 'vert!

The mechanic thinks its the ECU; he says,

"The ICM control signal (IGT) square wave fails as the engine fails. AC signal from crank sensor good at PCM."

The part number is 89661-2D690, but he also says $900+ for the part. Can anyone offer suggestions for getting my Celica up and running again - for preferably a lot less money?

Sep 13, 2012 - 9:10 PM Forum: Interior/Audio/Electrical/Wiring · Post Preview: #987225 · Replies: 10 · Views: 227,359
AwesomeRob

Enthusiast

Joined Sep 6, '12
From Eugene, OR
Currently Offline


You might have been right! I went back today (a rare sunny fall day in Oregon!) and noticed one of the interior panels was mis-installed. I went back and checked everything behind both, and under both seats, wiggling wires and squishing Molex connectors together. I'll be damned - it works again and the seat belt light is off too!

Sep 13, 2012 - 4:08 PM Forum: Interior/Audio/Electrical/Wiring · Post Preview: #987187 · Replies: 13 · Views: 6,026
AwesomeRob

Enthusiast

Joined Sep 6, '12
From Eugene, OR
Currently Offline


I had the rear windows DISCONNECTED for the last year, and connected them again last week. Everything (except the rear windows) worked fine until yesterday.

Sep 13, 2012 - 12:02 AM Forum: Interior/Audio/Electrical/Wiring · Post Preview: #987099 · Replies: 13 · Views: 6,026
AwesomeRob

Enthusiast

Joined Sep 6, '12
From Eugene, OR
Currently Offline


My '97 did the same thing today, neither motor makes noise and the damn "fasten seat belt" light stays on; WTF little car!? Did you ever find a solution?

Sep 12, 2012 - 11:43 PM Forum: Interior/Audio/Electrical/Wiring · Post Preview: #987097 · Replies: 3 · Views: 2,924
AwesomeRob

Enthusiast

Joined Sep 6, '12
From Eugene, OR
Currently Offline


THANK YOU!!! This worked a charm!!! I can tell I shouldn't mess with them now thatthey are both up (motors sound weak) but at least it's in the up position!! In Oregon windows up is important!

Sep 12, 2012 - 11:40 PM Forum: Interior/Audio/Electrical/Wiring · Post Preview: #987095 · Replies: 10 · Views: 227,359
AwesomeRob

Enthusiast

Joined Sep 6, '12
From Eugene, OR
Currently Offline


I had exactly the same issue today - did you ever figure it out?


New Posts  New Replies
No New Posts  No New Replies
Hot topic  Hot Topic (New)
No new  Hot Topic (No New)
Poll  Poll (New)
No new votes  Poll (No New)
Closed  Locked Topic
Moved  Moved Topic
 

Lo-Fi Version Time is now: January 10th, 2025 - 4:52 PM