Jul 1, 2014 - 11:58 AM | Forum: Buying/Selling · Post Preview: #1049993 · Replies: 9 · Views: 1,409 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Jun 18, 2014 - 8:17 PM | Forum: Engine/Transmission/Maintenance · Post Preview: #1049194 · Replies: 0 · Views: 847 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Happened on the way had music on heard something rattle? Well cruising at 60 suddenly speed goes down and rpms go up like I'm in neutral except 5 th gear. A week ago car kept popping out of 5th gear when I let go of gas pedal. Then it stopped. Recently had new driver axle installed. So linkage issue or clutch? Hoping it's linkage. Any one have picks of where it is located. Thanks |
Jun 10, 2014 - 7:45 PM | Forum: General Discussion · Post Preview: #1048697 · Replies: 10306 · Views: 1,179,251 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Drove home and let go of the gas pedal for a moment and hit the gas then car was in neutral?!?!?! Had a 18 wheeler behind me scared me. I'd check your clutch for slipping. Get up to 30 mph and throw it into fifth and then floor it, look for RPM's rising while the speed stays the same. I'll try that on the way home from work. But Idk what's the issue I got it to consistently "slip" out if fifth gear today. Cruising at different speeds 60, 50, 40 in fifth and then releasing the gas pedal. Gear knob goes into neutral. I tried holding the gear physically but then it grinds. After it slips out of 5 th I tried to go back into it but I cant. I end up dropping into 4 and then back into 5 |
Jun 10, 2014 - 2:16 AM | Forum: General Discussion · Post Preview: #1048621 · Replies: 10306 · Views: 1,179,251 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Drove home and let go of the gas pedal for a moment and hit the gas then car was in neutral?!?!?! Had a 18 wheeler behind me scared me. |
Jun 3, 2014 - 8:29 PM | Forum: Engine/Transmission/Maintenance · Post Preview: #1048118 · Replies: 2 · Views: 1,026 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
http://m.oreillyauto.com/mt/www.oreillyaut...n_jtt_v_thumb=1 Seems like a good cheap deal so what's the catch to this? Anyone used/use these |
May 30, 2014 - 2:59 PM | Forum: Engine/Transmission/Maintenance · Post Preview: #1047812 · Replies: 4 · Views: 616 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Ya I saw the o2 sensor wire had been cut. I have a short site intake and the hole for the wire rubs against the side of the reservoir for one of the mastercylinders? There's a cut in the wire but do I really need the sensor |
May 30, 2014 - 12:32 PM | Forum: Engine/Transmission/Maintenance · Post Preview: #1047805 · Replies: 4 · Views: 616 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Well seems like I fix one thing and then I get another. So from what I have research. Code 24 is "Intake Air Temperature Sensor signal" and code 27 "Sub Oxygen Sensor signal" Looking thru the forum don't see much just on these two codes. First code 24 seems like it's a vacuum leak? Or is there an actual sensor? Like that one that goes in the intake box or cai. Code 27 no idea what a sub o2 sensor signal is..... |
May 24, 2014 - 1:16 AM | Forum: Suspension/Handling/Braking · Post Preview: #1047409 · Replies: 4 · Views: 1,157 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Bought new cv axle from o Riley. Not remanufactured. Had a guy put it in for 50 in a local garage. On the way home I noticed the car vibrates on steering wheel very strong when around 60mph. Also road noise has gone up. On the way home she started to pull right strongly. So did I get a dud or did the guy put it in wrong? |
May 22, 2014 - 11:21 AM | Forum: General Discussion · Post Preview: #1047289 · Replies: 10306 · Views: 1,179,251 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
![]() Weekend work |
May 4, 2014 - 11:38 AM | Forum: General Discussion · Post Preview: #1045684 · Replies: 6 · Views: 1,276 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Welcome buddy Try using the search bar and info tab. There's a lot to learn. 3Sgte, beams, or v6. Check oout progression threads lots of info of different swaps there |
May 4, 2014 - 11:28 AM | Forum: General Discussion · Post Preview: #1045683 · Replies: 9 · Views: 3,670 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Easy get a lawyer. Every state is different though check with one with good rep. If I'm not mistaken they do charge a consulting fee but if you stick with the lawyer it is with the bill. Lawyer here runs from 350 to 600. And make sure to see if that is the final cost that should include court fees and any other fees your state charges. So no worries buddy. I've had 4 last year 3 speeding and 1 passing in a intersection. Lawyer drop 3 ended up with one point. Got another last month in my celica...was profiled out of a group with vette. Now I'm going to take a hit on my insurance. But don't forget they can only do soo much. My theory is if you don't have heavy pockets don't have heavy feet. |
May 2, 2014 - 9:37 AM | Forum: Exterior Styling · Post Preview: #1045569 · Replies: 3 · Views: 1,435 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
http://www.carid.com/1995-toyota-celica-tr...CFS8OOgodUw8ATg I just can't picture how that fits in our cars |
May 1, 2014 - 7:09 PM | Forum: Exterior Styling · Post Preview: #1045530 · Replies: 3 · Views: 1,435 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Any one know what kind of trailer hitch fits or needs o be drilled into a 6gen |
Apr 28, 2014 - 9:25 PM | Forum: Buying/Selling · Post Preview: #1045260 · Replies: 39 · Views: 5,907 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Im going to suggest maybe going to mr2 forum to reach your limit |
Apr 22, 2014 - 12:28 PM | Forum: Buying/Selling · Post Preview: #1044744 · Replies: 0 · Views: 408 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Wtb 5sfe iac for a reasonable low price |
Apr 21, 2014 - 10:17 PM | Forum: Buying/Selling · Post Preview: #1044709 · Replies: 4 · Views: 566 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Aren't you doing a 3mz swap |
Apr 17, 2014 - 11:13 AM | Forum: Engine/Transmission/Maintenance · Post Preview: #1044311 · Replies: 15 · Views: 1,385 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Thanks box after scouring engine bay for leaks i noticed o2 sensor in exhaust manifold the wire was split in half and no even connected. Put a butt connector on her started her up idles even higher now at 3k even with tps set... I am going to asume that the o2 sensor is bad causing high idle and code 25. Want a confirmation before i go to junk yard. Camry o2 should work right? |
Apr 16, 2014 - 1:31 AM | Forum: Engine/Transmission/Maintenance · Post Preview: #1044178 · Replies: 15 · Views: 1,385 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Drove her to work today. Noticed she ate up some gas. At half a tank about 50 miles a little over a quarter left. On the way home tonight i pulled a code 25. Ill check and see what it is tomorrow. ![]() |
Apr 15, 2014 - 12:02 PM | Forum: Buying/Selling · Post Preview: #1044111 · Replies: 13 · Views: 3,854 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Toyota Celica 94-99 2.2l 5SFE Stainless Steel Headers Exhaust M2 Performance by M2 Performance http://www.amazon.com/dp/B002FCC4YG/ref=cm...d_xxwttb1SRZX7P |
Apr 15, 2014 - 11:59 AM | Forum: Buying/Selling · Post Preview: #1044110 · Replies: 13 · Views: 3,854 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Apr 15, 2014 - 11:02 AM | Forum: Buying/Selling · Post Preview: #1044104 · Replies: 13 · Views: 3,854 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Im disappointed i was thinking you were going for a turbo set up. |
Apr 14, 2014 - 7:39 PM | Forum: Engine/Transmission/Maintenance · Post Preview: #1044071 · Replies: 15 · Views: 1,385 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Thanks you guys for your advice. Ill do a follow up |
Apr 14, 2014 - 10:21 AM | Forum: Engine/Transmission/Maintenance · Post Preview: #1044022 · Replies: 15 · Views: 3,757 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
mad aint even the word, im to the point of about to leave it in a parking lot with the keys in it and hope it gets stolen.... I take it off your hands. Leave it in a parking with keys and pink slip ill pick it up for you buddy. Your not far from me. Then you wont have no worries |
Apr 13, 2014 - 11:23 PM | Forum: Multimedia · Post Preview: #1043993 · Replies: 400 · Views: 1,124,670 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
Apr 13, 2014 - 11:05 PM | Forum: Engine/Transmission/Maintenance · Post Preview: #1043991 · Replies: 15 · Views: 1,385 |
Enthusiast ![]() Joined Jun 8, '13 From goldsboro, NC Currently Offline ![]() |
![]() ![]() ![]() ![]() |
![]() ![]() ![]() ![]() |
Lo-Fi Version | Time is now: April 22nd, 2025 - 6:37 AM |