6G Celicas Forums

Hi!
This is not in any way dangerous, and it is safe to drive with your car. To solve the problem, you have to add some copper ease (high temperature grease) to the back of your brakepads. This wil eliminate the vibration for the brakepads to stop the squealing. Oh, and you might notice that when you have braked some, ie the pads have become warm, the sound maybe gone?

That can't be his car. This car has a Finnish flag, Petter Solberg is Norwegian

Thank you Hanyo! It was the belt tensioner bearing, i squirted some wd-40 on the bearing while the engine was running and the sound stopped! Great

Where does this sound come from and how do I fix it?

Video with the sound

Maybe a little dark, but these are 215/40/17

Had a trip over the mountains this weekend

Are you low on brake fluid?

It should jiggle a bit, when you put your wheel on, it will be tight.

Your amps should have a remote wire connected to +12V on your cd player/head unit. The amps will then power up when you turn your key one "step" in the ignition.

The multimeter is fused, so the 10A means that it has a 10A fuse. I guess you have a 200 mA fuse where you have the VΩmA port. So, connect the red lead to the 10A port first to check if the draw is higher than 200mA, if not, you can connect the red lead to the 200 mA port. The black lead goes to port COM. Set the dial on the multimeter to ADC 10A first. You can clamp the black lead to the battery negative post, and the red one to the negative lead cable. Then start pulling fuses and you can see wich circuit that has the draw. Hope this helps

Question.

I got a Apexi power filter, when should I replace it?

No noise when turning, I'll check the motor mounts today.

Thanks for all the replies. I haven't been able to check the mounts yet, but I was out driving today and if i let go of the throttle fast at let's say 3000rpm I heard the clunk and the car makes a little hump. This happends in every gear. I tried starting the engine and look at it when i sat in the car, but I couldn't say that it shakes alot. I also tried to rev it a bit, but it didn't shake just move a bit.

Would this be normal to happen? Cars got 73300 miles.

I said it happens more often when the car is cold, but that could be just me. Are motor mounts expensive? Can I check it myself?

I hear a clunk when I put my Celica in gear and let of the clutch. I just wanna hear if somebody got a quick dianose for this problem. It kinda sounds like when you release the clutch quickly. It happens more often when the car is cold. It can also happen if I let go of the throttle quickly. Could it be bad axels, motor mounts?

How about international shipping? (Norway)

I paid $18,500 for my celica. Hahaha..Yup, cars are expensive in Norway....Dunno about sweden! I got a 1995 GT (3s-ge), leather, A/C was 99000km when I bought it.

Oh, and $10,700 was taxes

My fockford fosgate amp did that. After about 5 mins it would shut down, no sound at all..I was like It turned out to be the cables I used for a set og 6x9. The cables was too thin, some bundle stuff. So I upgraded the cables and the problem went away

And you are not deaf now?

Maybe it is some sort of old alarm component, maybe some Gps stuff?

I use Goodyear Eagle F1 GSD3, and must say
Best tires I ever had!

Here is a pic

You know what came in my mail today, from Hong Kong?
My new JDM tails!! I have put them on and i'll upload some pics later. They are sexy!
Great GB snap! Thanks

They are not paying for it, they said that they had to remove the sensor and it was impossible to take it out without breaking it..Are brembos good?