6G Celicas Forums

Good afternoon, I'm removing the head from the car to replace the gasket.

The problem arises when, to remove the cylinder head, all the wiring that goes above the intake manifold must be removed.
To remove all the wiring you have to disconnect many things, so the solution for me is to remove the intake manifold

This one has reinforcements underneath and some screws from the bottom that grab it to the butt, but you can not put the hand behind.

For the guys who have removed the cylinder head or intake manifold, exactly how did you do it?

Many thanks

p.d: WIRING/CABLE

Yea and no

In other marks are used "stages" to designate the different levels of preparation ... I know that in toyota and in particular celica all trac are not used.

I expected you to "invent them" since I have not yet seen levels of preparation "established" and wanted to have some concrete information ...

For example:
Stage 1: downpipe, improved air filter in original air box, original turbo 1.1 bar

Stage 2: downpipe, improve fuel system, original turbo 1.1; Air box "TTE",

Stage 3: downpipe, another turbo, etc.

In any case I feel I have expressed wrong, what could modify without changing the original turbo (ct26) and the ECU

What material / brands to assemble and where to find it?

Many thanks

Good evening, I own a Celica GT-Four st185 and I would like to know what stage 1 and 2 would be and if there would be something intermediate

Many thanks