6G Celicas Forums

Mind you, I can only speak for the Alberta OOP.
The low beams and installation of Daytime running lights were the only changes on my car. The JDM reflector lamps and JDM projector lamps are not DOT approved. You will have to source out a USDM set of low beams.
Sidemarker was ok, there was a 3rd brake light, and they didn't note the lack of red reflectors

The side rain visor actually works quite well for me.
I live in the climate where I have to use my washer fluid quite often and when doing so, it washes the grime and throws it to the edge of the A-pillar. While driving without the side rain visor, the fluid would follow the lip between the wind shield and the A-pillar up and around to my side windows. This leave unsightly streaks on my window and I don't appreciate it. After installing the side rain visor the fluid wouldn't run on to the side window which does exactly what I need it to do.

So from my experience and expectation, it's a good investment.

How much for the good pair of high beams to Calgary Alberta?

I think I have that lying around.

I'll look for it.
check pm

--------------- start copying here ---------------------

1. ChrisD (Chris) - 88 ST165 or 94 ST205, whichever is ready
Need lodging: Yes, 1 adult, August 9-12
chris_dittrick \AT\ yahoo.ca

2. KAOS (Jeremy) - '94 RevIII 3SGE Swapped GT-S
Need lodging: Yes, 1 adult, August 9-12
jdwinterton \AT\ gmail.com

3. WALKER (David) - '94 ST205
Need lodging: Yes, 2 adults, August 9-12
walker \AT\ gt4wrc.com

4. Schweizerceli (Sean) - '92 RC or '94 WRC
Need lodging: Yes, 1 adult, Aug 9-12
sean.baertsch \AT\ gmail.com

5. Artega (Denis) - 94 ST205
Need Lodging: Yes, 2 adults, August 9-12
artega555 /AT/ gmail.com

6. username (name) - Ride
Need lodging: Yes/No, # adults, date range
Email
-------------- end copying ----------------------------

Whoa! Zombie thread from 7 years ago.

that would make it really look like an Aston Martin

Other than the Veilside kit this would've been real nice.

I demand more pictures!

I'm got the foglight housing as well as the plastic grill surrounds across the front.
I perfer to sell both together and we're nearby so perhaps you'll save on shipping too.

PM me

actually Junyan is a Taiwanese company that seems to be specializing in aftermarket lighting solution.

I'm not sure how rare these guys are but it's certainly not rare as in they are limited edition. It may be rare because no one buys them.
Check out their website here
http://www.junyan.com.tw/products.asp?ProI...&CatName=TY

They sell them by the lots.

Anyways they do look like the autoart light.

I wouldn't buy them for $400

What's the small indicator version?

Did you mean the GT4 jdm fenders with the indicator near the door?
If so, then send me a pm

Did you just happen to acquire a set o late spec on eBay?
Don't tell me I was bidding against you.

why don't you just buy a GT4?
it'll save you all the upkeep of having a high mileage car

These don't fit the St205 unless you've relocated your TMIC. but other wise the speedo will be pretty cool.
If you do buy it let me know how it fits.

Cheers.

I had the same problem. Cold start would stall unless I hold the throttle up. I would blip the throttle and it would rev then come back down below where idle should be and then stall.
So this problem for me actually happens while I’m driving and shifting gear.

I changed out the Throttle position sensor and it didn’t help.
Finally took it into a shop and they couldn’t come up with anything. But they did adjust my TPS while connecting it to OBD reader. The problem went away.
So for me the problem might not be a faulty TPS, but it fixed the problem after it was properly adjusted.

I hope that helps.

Similarily with the Thermwell FrostKing Duct insulation that everyone's using to sound proof their car.
We don't get these in Canada.

....all we got are GT-fours

Calgary group buy?

Wow!!

Checked out teshi's build thread and I am absolutely amazed at the customization he went through.
Google Translate is good, but without translating every post, Marco can you tell us why the original bumper fitment so poor?

This would allow you to make your own projector with the stock headlight housing. Good job.
But please don't run these with your stock bulbs. The pattern on the glass is meant to direct the lights onto the ground and not to up toward another driver's eye. taking away the glass essential turned your low beams into high beams.

With that said I might order one as I have a set of JDM stock highbeam that's available for the projector treatment.

Good luck with the sale

it should be an oem sticker saying it's to be changed at 100,000km

I got mine crossed out and the actual km changed written on there (by a Japanese mechanic)

now's the perfect time to upgrade to a proper boost gauge

High beam for which side? I'm also interested in the highbeam seals

pm please.

I like the arising II rear much more than the extremor rear

Does it fit the GT4 the same as the GT and ST celica?

so.....I missed the boat on this?

DAMMIT

interested in the rear lip and the side skirt.

How much? Debating between this or RT-performance kit.
thanks

Pm'ed