6G Celicas Forums

Thinking about upgrading my ECU to a MS-III.

It can control up to 4 injectors individually (or have them set up in banks like the OEM ECU does) and 1 coil (the distributor only uses 1 coil).
It has an internal 3-bar MAP sensor (good for I believe up to 21 PSI)
Can be tuned with any ECU and requires no fancy cable, just an RS232 to USB converter which I can either include for extra with the ECU, or you can purchase from their website.
It is setup to control 2-step, PWM control and table switching, which would cost extra if you were to order from their site.

Asking price: $450 OBO w/o wiring harness (they sell it on their website, too)

Feel free to ask any questions.

This post has been edited by Syaoran: May 11, 2013 - 1:13 PM

I'm surprised your not just adding the MS3 card on to it. Thats like $100 saved......

The card, plus the 40$ case plus the labor comes to just about the same for me.

What motor is this for?

Any engine, it's not a plug-n-play kind of deal.

You could use it on a BEAMS, on a 3SGTE, on a 5S-FE, on a 7A-FE, and even a 1MZ-FE if you wanted. As-is, it can run any of our 4-cyls (since they all run on distributors which only use one coil and are all batch-fire injection) It can be modified to run up to 8 cyl engines, and can run full sequential as well with soldering of new circuits.

If you include Labor than thats a different story.

Sold locally.