FS: 95 Celica GT Part Out, needs to be gone buy June 1, 2013 |
FS: 95 Celica GT Part Out, needs to be gone buy June 1, 2013 |
May 14, 2013 - 3:18 PM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
line that connects to the master cylinder clutch to the slave....the whole line...93727 or probably pick up I have to check on how to take that off. how much would you ask for the passenger side seatbelt assembly? Will give you an update on that later today. Original Post updated -------------------- God made man....
Everything else... Made in China |
May 14, 2013 - 4:47 PM |
|
Enthusiast Joined Jun 18, '09 From Orlando Currently Offline Reputation: 8 (100%) |
What Mike said, the frame for the rubber is the same, but the gasket piece directly around the cables is unique to the manual. I am going by the assumption that you have the interior apart, so it's not that hard to get to. Underneath the car then are four nuts for the exhaust shield and then three bolts for the other side of the gasket. It took me about ten minutes to remove from another car.
Please, and thank you. This post has been edited by SwissFerdi: May 14, 2013 - 4:48 PM -------------------- '97 ST \ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+ [sold 10/18]
'93 MX-5 LE |
May 14, 2013 - 5:07 PM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
What Mike said, the frame for the rubber is the same, but the gasket piece directly around the cables is unique to the manual. I am going by the assumption that you have the interior apart, so it's not that hard to get to. Underneath the car then are four nuts for the exhaust shield and then three bolts for the other side of the gasket. It took me about ten minutes to remove from another car. Please, and thank you. The dash is mostly intact still. I will try to get that for you then. Thanks -------------------- God made man....
Everything else... Made in China |
May 15, 2013 - 12:12 PM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
Orig post edited
-------------------- God made man....
Everything else... Made in China |
May 15, 2013 - 1:09 PM |
|
Enthusiast Joined Mar 15, '12 From Wrightstown, NJ Currently Offline Reputation: 6 (100%) |
How much would you like for the passenger side window and lock control panel (assuming it's not already taken, and all the tabs are intact)? A pic of mine so you know what piece I'm talking about.
This post has been edited by PaukST: May 15, 2013 - 1:17 PM -------------------- 1989 Celica ST Automatic "King Cobra" -- 2005-2006
1994 Celica ST 5-speed "King Cobra II" -- 2011-???? |
May 15, 2013 - 1:59 PM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
How much would you like for the passenger side window and lock control panel (assuming it's not already taken, and all the tabs are intact)? A pic of mine so you know what piece I'm talking about. PM sent -------------------- God made man....
Everything else... Made in China |
May 15, 2013 - 9:37 PM |
|
Enthusiast Joined Aug 5, '09 From West Texas, USA Currently Offline Reputation: 20 (100%) |
Is the fuel/gas door in good shape?
-------------------- |
May 15, 2013 - 9:54 PM |
|
Enthusiast Joined Mar 25, '13 From Sherman Oaks,CA Currently Offline Reputation: 0 (0%) |
How much do you want for the trim pieces around the radio and gear shift?
|
May 15, 2013 - 10:54 PM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
Is the fuel/gas door in good shape? Yes sir, i can take a pic tom. How much do you want for the trim pieces around the radio and gear shift? The one around the radio has been sold. The gear shift trim would be $15 + shipping. -------------------- God made man....
Everything else... Made in China |
May 15, 2013 - 11:15 PM |
|
Enthusiast Joined Aug 5, '09 From West Texas, USA Currently Offline Reputation: 20 (100%) |
Is the fuel/gas door in good shape? Yes sir, i can take a pic tom. Sounds good. how much do you want with shipping? My zip is 79424. -------------------- |
May 16, 2013 - 1:53 AM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
Is the fuel/gas door in good shape? Yes sir, i can take a pic tom. Sounds good. how much do you want with shipping? My zip is 79424. will calculate and get back at you. Thanks -------------------- God made man....
Everything else... Made in China |
May 22, 2013 - 2:33 AM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
Bump! Update on original post
-------------------- God made man....
Everything else... Made in China |
May 22, 2013 - 7:54 AM |
|
Enthusiast Joined Jun 18, '09 From Orlando Currently Offline Reputation: 8 (100%) |
The dash is mostly intact still. I will try to get that for you then. Thanks A friendly bump for this. -------------------- '97 ST \ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+ [sold 10/18]
'93 MX-5 LE |
May 22, 2013 - 12:29 PM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
The dash is mostly intact still. I will try to get that for you then. Thanks A friendly bump for this. Thanks Ferdi, I had time to take apart the dash. I will look into your gasket! -------------------- God made man....
Everything else... Made in China |
May 22, 2013 - 3:53 PM |
|
Enthusiast Joined Mar 15, '12 From Wrightstown, NJ Currently Offline Reputation: 6 (100%) |
Got the window/lock control panel today, it's in great shape! Thanks a bunch!
I'm also interested in a bunch of other pieces, that I didn't think of before... 1) the shifter plastic trim (does it have all/most of the tabs for holding the shift boot?) 2) the short cable that goes from the rear hatch latch mechanism to the rear hatch lock 3) the aim-able passenger side climate control/blower vent closest to the door (if it still has most of the tabs to hold it in place) 4) the driver side mirror 5) the turn signal/headlight switch 6) the windshield sprayer nozzles (assuming they're not clogged) 7) the entire hood latch mechanism (the handle thing under the dash, the cable from there to the latch, the latch mechanism itself, and the loop on the underside of the hood that it hooks onto, and all the bolts/screws to go with it) I'm also trying to get the inner fender well plastics, but they'd probably be way expensive to ship due to their size. If they won't be super expensive to ship I'd love a price on those as well. I wish I'd gotten to your thread sooner - I'm trying to get myself that rear hatch cover as well, but someone beat me to it -------------------- 1989 Celica ST Automatic "King Cobra" -- 2005-2006
1994 Celica ST 5-speed "King Cobra II" -- 2011-???? |
May 22, 2013 - 4:13 PM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
Got the window/lock control panel today, it's in great shape! Thanks a bunch! I'm also interested in a bunch of other pieces, that I didn't think of before... 1) the shifter plastic trim (does it have all/most of the tabs for holding the shift boot?) Yes it still has the tab for the shift boot 2) the short cable that goes from the rear hatch latch mechanism to the rear hatch lock available 3) the aim-able passenger side climate control/blower vent closest to the door (if it still has most of the tabs to hold it in place) one tab is broken, still work, i tried it 4) the driver side mirror available 5) the turn signal/headlight switch available 6) the windshield sprayer nozzles (assuming they're not clogged) maybe clogged, not recommended 7) the entire hood latch mechanism (the handle thing under the dash, the cable from there to the latch, the latch mechanism itself, and the loop on the underside of the hood that it hooks onto, and all the bolts/screws to go with it) available I'm also trying to get the inner fender well plastics, but they'd probably be way expensive to ship due to their size. If they won't be super expensive to ship I'd love a price on those as well. I wish I'd gotten to your thread sooner - I'm trying to get myself that rear hatch cover as well, but someone beat me to it a lot of people had interest on it Will PM you tonight on the details. Pleasure doing business with you! -------------------- God made man....
Everything else... Made in China |
May 22, 2013 - 4:17 PM |
|
Enthusiast Joined Feb 2, '07 From Berlin, WI Currently Offline Reputation: 18 (100%) |
are floor mats still available?
-------------------- *1997 Celica ST - 3SGE Greytop BEAMS *1977 Celica RA29 - Classic Cruiser *2005 Matrix AWD - dedded but still hanging around like a ghost 2019 Rav4 XLE Premium - Sports mode is fun. |
May 22, 2013 - 4:18 PM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
are floor mats still available? Yes, they are the 25th anniversary floor mats -------------------- God made man....
Everything else... Made in China |
May 22, 2013 - 11:27 PM |
|
Enthusiast Joined Jul 2, '12 From Clifton, NJ Currently Offline Reputation: 0 (0%) |
Is the climate control, you posted a picture of, still available?
|
May 22, 2013 - 11:28 PM |
|
Enthusiast Joined Feb 15, '08 From Royal Oak, MI Currently Offline Reputation: 7 (100%) |
Is the climate control, you posted a picture of, still available? Yes it is, what is your zip? -------------------- God made man....
Everything else... Made in China |
Lo-Fi Version | Time is now: November 25th, 2024 - 3:27 PM |