6G Celicas Forums

^ that's the type I was looking at.
And still, mods or not, photos would be sweet!
Keep us posted about that cruise/I might join that forum.

And yep, I hate 4wd and busses. Busses just merge out when they want and you have to go around.
But I have the type of smart-arse attitude where I give them a chance to get over, if they miss that window I tail the person in front so they can't get in. Having a somewhat loud exhaust and manual is good to rev it past them

Mine has that, I turned it off when it started recording all night because it wasted my battery....

Also once the motion detector comes on, it doesnt turn the cam off, so unless you come back to the car in the time it takes to fill the card it will just overwrite it again...

All of a sudden I'm somewhat more thankful for the United State's complete lack of public transit.

Nice clean car man! I miss my celica...I don't miss the problems though lol.

Thanks Man


UPDATE:
Splitters were painted and put into heat room this morning; They were put on this arvo and we attended the meet

Will post photos soon

i was thinking the same thing

UPDATE:
So I have now got the splitters painted and installed:
Before:





After:

Really nice! Looks good! I was thinking about TRD rear splitters too, but ended up on SS-III but I should think about it once again....

Yeah, I prefer the TRD over the SSIII for the rear for my setup, the TRD flow a lot better

I am thinking SSIII for the front

looks good lose the ford plate surround though..

Have both and swap rotate them monthly.

I am going to black it out pretty soon

When I can find a good quality surround that fits the Australian Number plates that I want, I will upgrade to them

Might contact toyota about it

Found this photo from the TOC annual meet early this month:

Just some photos as I was driving home tonight:






And At home:

*removes all the TRD badges* See, much better.

So, The big update is finally here
A few week ago I found a set of Projector Headlights on eBay and promptly purchased them. After a week, they were at my door...
I opened the box, and as usual, one tab was broken and another was split




So I got a bottle of Loctite 406 from my Girlfriends father and repaired those tabs. I also added a washer behind the completely cracked tab for extra strength =]



Now came the adapter problem... The stock wiring in the car doesn't fit the H1 socket on the projectors, and the ADM park lights don't fit in the accent lights either... So an adapter was needed to be made... I got onto eBay and found some extension cables for the stock ADM wiring, and luckily the eBayer gave me the H1 side and the Accent adapters, so all I needed was the Male side for the low beams


And so, this morning I headed over to my Mates house where most of the Car work is done. Here is the 'Before' shot:


Following the 6GC bumper removal guide, hte bumper was off in less than 40mins




After some further troubles of trying to get a 10mm spanner that would fit inbetween the bar and the light, we finally got the High Beams replaced. They are a direct replacement and so no wiring mod was required


Once the low beams were out of the car, it was time for the wiring harness to be made. The eBay extension cable was cut, and the male half was soldered and headshrinked onto the H1 adapter. In 10mins, both sides were made and the adapters were installed and 10mins later, the Low beams were in place. The Accent lights were just soldered directly onto the ADM park light harness:




Testing followed:


After the test was successful, the car was rebuilt and photos were taken. These will be in a second post below

This post has been edited by rentaspace: Jul 13, 2013 - 3:50 AM

And the photo update, I DID wash the car (finally):








Will be getting some high-res photos soon

Yay, yay, yay..... Wait..... You mixed blue and yellow lights -.- Are you planning to change you low beams to the same colour temp you had on there before?

The 'Blue' is actually white... The time of day changed that...
And ATM I am not sure, I can get the H1 'Xenon' White Lights for $15, but I don't know if I will...
It will look better I guess

Starting to look pretty schmick here man. I say just bite it and buy yourself some HID's now you have the appropriate headlights!