6G Celicas Forums

Today I went to get a quote on the Labour for clutch replacement. Any recommendations for a stage 1 clutch? Budget is £200 as I won't be keeping the car too long. Just can't bear to see it in a less than driveable condition.

Just get an Exedy OEM replacement, they're made in Japan and are great quality for a fair price.

Found and ordered a exedy stage 1 clutch lol should still feel kind of oem hopefully. Bit over budget tho. Thanks box.

Today I decided that I'm going to save money up and eventually have someone swap my car to a 3sgte. But that's way way down the road.

I ordered a Aisin oil pump $78, Aisin timing kit with water pump $88, and Aisin clutch kit for $133 on rockauto

Finally installed my new shift boot from kurts wife, bringing the car back update, out with the old in with the new

Topped off my powersteering fluid today. I think I may have a leak somewhere.....

I decided to watch the gt-four perfourm

Today I discovered my tps went out.....again. Going to the dealer and picking up an oem one instead of one from rockauto or autozone.

I'd say you Can get a Toyota tps from picknpull. In fact it fits right in your pocket, buy a radiator hose or something ;p

Dozens of Camry's have the same motor.

I'm just going to pay the money and get a brand new one. I don't want to run the risk of it not working or it going out like mine in a short time.

Does any one know of any one that has chrome deep dish 5spoke rims on their celis?

A used OEM one would be fine, I'd hate to know how much you're paying for a new one.

In this case I'm okay buying new but I'm going to buy from partznet. Car is acting fine now, no codes, so I don't need it immediately. Dealer wanted to much money for it and since I don't need it asap I can save money and buy online.

got my new brake lines

drums to disc brake conversion just need to finish up ebrake line

You're still alive! Haven't seen anything from you in years. How was the conversion? Parts list?

The other day I was doing some painting and ended up peeling a huge piece of paint off Took it to the shop that replaced the bumper from when I got rear-ended and they said they'll repaint it for free.



Also got some rust cut out from my rocker panel and new metal welded in last week and painted it this weekend. Doesn't look perfect, but I'm saving up for a full paint job anyways so I'm not too concerned. While I was doing that I also tried doing some eyelids on my highs with plastidip, it turned out alright but some of the edges peeled up when I peeled off the tape.

With plastidip you peel the tape immediately after you spray. Probably only need 3 coats for eyelids and you can spray them on in 3 minute increments since it's such a small area and drying won't matter much because of that

I did peel it off right after spraying, but I did quite a few coats so maybe that's why it peeled up