6G Celicas Forums

This is assuming you have taken off your door skin...

Tools: screwdrivers, socket wrench, 10mm and 12mm deep socket


The bolts holding on the regulator and motor are circled


First you want to line up these holes by moving your window up and down
take these bolts (10mm) off and your window will slide out the top, you have to tilt the side connected to the car down to get the window stopper out.


Unbolt the top bolts (10mm) and slide these out


Unbolt the bottom bolts (10mm) slide this off, then remove the nut (12mm) underneath it.


Disconnect the motors wires, you have to unclip it from the car shown with the arrow, and disconnect if from the other clip. After that remove the three bolts holding the motor in.


Now the entire assembly will tilt and slide out the main hole in the door panel.


Replacement part


Remove these two bolts and the metal bracket they hold on.


With the cover removed you can use a flat screwdriver to pry the old pully off the motor

Installation is reverse of removal


Once you have the motor and regulator back in, connect your window switch up and move the regulator up or down till these holes line up. Reinstall the window. Dont Tighten these bolts up all the way yet, leave enough for the window to move around.


Roll the window up and tighten them all the way using these service holes and the window should be lined up correctly. Just dont break your window tightening the bolts too much.

Install the door skin and your done

This post has been edited by Stu37363: Mar 22, 2006 - 10:56 AM

nice how-to

should be stickied

agreed!

Very detailed how-to
How often do these regulator stop working?
and how much are they to replace?
I vote sticky as well!

not sure how often they stop working, my car has about 45k miles on it, but i smoke so that window goes up and down all the time.

the part cost me about $100 at a local dealership.

This post has been edited by Stu37363: Jun 11, 2008 - 10:26 AM

I find this very useful. Shouldn't it be stickied?

my cable is broke so that means i have to replace to whole arm with cables 100$ bucks i dont have....but still good how to

STICKIE

oh hot diggity dog, this covers about 3/4 of the info I need! yay! I'm SO bookmarking this!

look thru the junkyards if ya can..i had a regulator for sale as i did this exact procedure, but i sold it to another member.

i bought the window, regulator, and switch for $65 at a pick-a-part. if ya have anything similar close by, i'd recommend it as it is summer and a quick fix will probably last ya a while until you can afford the new part. (the regulator alone was only $25)

This post has been edited by xs94st: Jun 13, 2008 - 4:01 PM

how can you unscrew the last 3 bolts if your window cable is broke and cannot move the window up?

http://www.1aauto.com/1994-99-toyota-celic...2063&y=1995

1995 Toyota Celica Power Window Regulator (Without Motor) Driver Side

I cant find this locally.. would this be okay?

damn.. yea i cant find it at any of the local shops. pick a part places around here are all picked. Gonna have to order it online.

Anyone have a cheaper source?

This is for a 1995 toyota celia (Duh haha) ST driver side power window regulator. That 1a auto is 109.95 plus shipping. Ill wait a day before ordering..hopefully one of you guys/gals can come thru with a better source. thanks in advance!

This post has been edited by benzo: Oct 27, 2014 - 7:29 PM