6G Celicas Forums

Welcome Guest ( Log In | Register )

516 Pages V  « < 71 72 73 74 75 > »   
Reply to this topicStart new topic
> Today I..........................................
post Feb 3, 2011 - 10:57 PM
+Quote Post
Neon90424

Enthusiast
****
Joined Jan 19, '11
From Paraguay, Winchestertonfieldville
Currently Offline

Reputation: 1 (100%)




found out that my torsion bar thingy over the drive shaft is snapped


--------------------
post Feb 4, 2011 - 7:23 AM
+Quote Post
chacha

Enthusiast
*****
Joined Dec 29, '05
From So-Cal
Currently Offline

Reputation: 12 (100%)




finally finish drilling holes through the hatch...pain in the A$$. for the 2pt and for the varis roof spoiler...i won't put it on until the whole car is painted.
post Feb 4, 2011 - 2:26 PM
+Quote Post
Spider77



Enthusiast
*****
Joined Jan 17, '08
From JB MDL, NJ
Currently Offline

Reputation: 30 (100%)




Recieved my Aisin Water Pump and Timing stuffs..............now the weather needs to warm up!
post Feb 5, 2011 - 4:40 AM
+Quote Post
Giel-celica

Enthusiast

Joined Feb 11, '09
From Geleen The Netherlands
Currently Offline

Reputation: 0 (0%)




i'm gonna give the celica a good clean hasn't had a wash in 7 weeks so it looks like a mess right now. laugh.gif
post Feb 5, 2011 - 12:26 PM
+Quote Post
SwissFerdi

Enthusiast
*****
Joined Jun 18, '09
From Orlando
Currently Offline

Reputation: 8 (100%)




^ Geen zorg, die van mij is al sinds 21 augustus niet gewassen...ik schaam me wel een beetje. kindasad.gif

Gave her a much-deserved and needed oil change today.


--------------------
'97 ST \ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+ [sold 10/18]
'93 MX-5 LE
post Feb 5, 2011 - 4:26 PM
+Quote Post
azian_advanced



Enthusiast
*****
Joined Apr 18, '05
From Calgary
Currently Offline

Reputation: 20 (100%)




today i ran my fuel tank dry for the first time and had to push my car through snow while steering it to the closest gas station frown.gif


--------------------
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
post Feb 5, 2011 - 6:21 PM
+Quote Post
TEAMFaint



Enthusiast
**
Joined Nov 4, '06
From Medicine Hat, AB
Currently Offline

Reputation: 2 (100%)




Am ecstatic to say no more CEL for me smile.gif Stoked like you couldnt believe, been so long, glad I finally fixed the small issues.


--------------------
current project: looking :(
post Feb 5, 2011 - 7:22 PM
+Quote Post
SwissFerdi

Enthusiast
*****
Joined Jun 18, '09
From Orlando
Currently Offline

Reputation: 8 (100%)




Faint, good to hear. So I bet you're not selling anymore now huh?

Gerald, out of curiosity, where was the needle when the tank was truly empty?

My fuel flap retaining clip fell out after I filled up, oddly enough. Anyone have a picture of where this clip is positioned? I'm assuming it goes in the catch-thingy (no better word for it, sorry...latch? The black part that catches and locks the flap), because I see a little slot where it fits into. My flap now doesn't open without it having to be pried.

This post has been edited by SwissFerdi: Feb 5, 2011 - 7:23 PM


--------------------
'97 ST \ Eibach \ KYB \ Kenwood \ Alpine \ Cusco \ OEM+ [sold 10/18]
'93 MX-5 LE
post Feb 6, 2011 - 12:00 AM
+Quote Post
SupraKid



Enthusiast
*****
Joined Aug 15, '10
From The Best Coast
Currently Offline

Reputation: 12 (100%)




Flushed the front a bit more, and installed 4 new boston acoustic speakers biggrin.gif
post Feb 6, 2011 - 1:13 AM
+Quote Post
Neon90424

Enthusiast
****
Joined Jan 19, '11
From Paraguay, Winchestertonfieldville
Currently Offline

Reputation: 1 (100%)




replaced the broken stuff...I have run out of gas 4 times with my 205, that needle sucks I loved the digital 7gc gas marker...was so accurate...


--------------------
post Feb 6, 2011 - 1:31 AM
+Quote Post
mak5603



Enthusiast
****
Joined Oct 20, '08
From Seattle, WA
Currently Offline

Reputation: 5 (100%)




not good on your motor with the boost and no fuel kindasad.gif


--------------------
2006 BMW 330i - 6 Speed - Dinan Stage 1
2014 Toyota Rav4 XLE
post Feb 6, 2011 - 2:34 AM
+Quote Post
b22ri22an



Enthusiast
***
Joined Jun 2, '10
From Davenport, Florida
Currently Offline

Reputation: 0 (0%)




QUOTE (TEAMFaint @ Feb 5, 2011 - 6:21 PM) *
Am ecstatic to say no more CEL for me smile.gif Stoked like you couldnt believe, been so long, glad I finally fixed the small issues.

great got rid of yours and gave it to me smile.gif jk
I think i need a new vacuum modulator, i checked the new vsv i installed a few months ago and i hear a click when applying voltage, took the egr off cleaned the passage ways and tested it on a vacuum pump but i'm still getting a p0401 if anyone has anything i am missing please feel free to chime in


--------------------
post Feb 6, 2011 - 8:06 AM
+Quote Post
Neon90424

Enthusiast
****
Joined Jan 19, '11
From Paraguay, Winchestertonfieldville
Currently Offline

Reputation: 1 (100%)




It always happens when Im parked though...sucks big time...


--------------------
post Feb 7, 2011 - 10:22 AM
+Quote Post
dz93

Enthusiast
*
Joined Feb 2, '10
From nowra, nsw, australia
Currently Offline

Reputation: 0 (0%)




this is over last couple week.
ordered heaps of leds to replace the bulbs
entered 2 sound-off competitions and came 1st in both
plastic bit in radiator leaked (pin holes along the top, superglue + tape = temp fix)
and there was a earthing issue that i think i may have fixed smile.gif
also... got a st205 bonnet for $240 + 120 shipping... the bidding started at 150 and me and someone else were constantly going at it... if i were to of left it til last minute i would of gotten it cheaper. so on that note people, dont bid at all til late smile.gif

This post has been edited by dz93: Feb 7, 2011 - 10:24 AM
post Feb 7, 2011 - 10:24 AM
+Quote Post
KAOS



Enthusiast
*****
Joined Apr 18, '06
From Calgary, Canada
Currently Offline

Reputation: 37 (100%)




... am working from home, because its been melting like crazy here for the past few days, and then overnight it all froze again with about 20-30cm of snow on top of it. Makes for a horrid commute.

I'm not going to risk it.


--------------------
post Feb 7, 2011 - 2:57 PM
+Quote Post
b22ri22an



Enthusiast
***
Joined Jun 2, '10
From Davenport, Florida
Currently Offline

Reputation: 0 (0%)




visited New Image Auto Center Inc in Kissimmee and they pulled out my back seat and passenger seat to be recovered WOOT! freshly upholsterd seats will be installed next monday just in time for the Fl meet the following Sun. I went with dark charcoal vinyl outer and med charcoal preforated inserts my interior is gonna start showing some sexiness!


UPDATE: after talking to the guy doing the work I'm now getting the Celica Dragon embroidered into the front seats just have to decide what color, i'm thinking low key having it the same dark charcoal as the outer parts of the seat

This post has been edited by b22ri22an: Feb 7, 2011 - 11:10 PM


--------------------
post Feb 7, 2011 - 11:15 PM
+Quote Post
Araykhel

Enthusiast
*
Joined Sep 21, '10
From Woodstock, MD
Currently Offline

Reputation: 1 (100%)




Replaced a thermostat and gasket, first time removing components in the engine bay so it was very exciting. Reset the ECU while I was at it and now my idle is much smoother.
post Feb 8, 2011 - 1:07 AM
+Quote Post
azian_advanced



Enthusiast
*****
Joined Apr 18, '05
From Calgary
Currently Offline

Reputation: 20 (100%)




QUOTE (SwissFerdi @ Feb 5, 2011 - 6:22 PM) *
Gerald, out of curiosity, where was the needle when the tank was truly empty?


the needle was pointed in the middle of the letter E on the fuel gauge. i posted this same question in a thread a while back and i remember some guy posting that his needle went all the way below the letter E.


--------------------
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
post Feb 8, 2011 - 2:32 AM
+Quote Post
mak5603



Enthusiast
****
Joined Oct 20, '08
From Seattle, WA
Currently Offline

Reputation: 5 (100%)




QUOTE (azian_advanced @ Feb 8, 2011 - 2:07 AM) *
QUOTE (SwissFerdi @ Feb 5, 2011 - 6:22 PM) *
Gerald, out of curiosity, where was the needle when the tank was truly empty?


the needle was pointed in the middle of the letter E on the fuel gauge. i posted this same question in a thread a while back and i remember some guy posting that his needle went all the way below the letter E.


Not filling your tank all the way and just doing "$5.00 fill ups" etc. can cause your gauge to read improperly. I bet the person who said that does 5 dollar fill ups all the time.

Do you run your tank almost empty then fill it full every time? That's what it sounds like. That's the most ideal way to do it, after all the gas gauge should be accurate..haha.


--------------------
2006 BMW 330i - 6 Speed - Dinan Stage 1
2014 Toyota Rav4 XLE
post Feb 8, 2011 - 9:04 AM
+Quote Post
HectortheRican



Enthusiast
*****
Joined Dec 26, '09
From Albuquerque, NM
Currently Offline

Reputation: 19 (100%)




QUOTE (mak5603 @ Feb 8, 2011 - 2:32 AM) *
QUOTE (azian_advanced @ Feb 8, 2011 - 2:07 AM) *
QUOTE (SwissFerdi @ Feb 5, 2011 - 6:22 PM) *
Gerald, out of curiosity, where was the needle when the tank was truly empty?


the needle was pointed in the middle of the letter E on the fuel gauge. i posted this same question in a thread a while back and i remember some guy posting that his needle went all the way below the letter E.


Not filling your tank all the way and just doing "$5.00 fill ups" etc. can cause your gauge to read improperly. I bet the person who said that does 5 dollar fill ups all the time.

Do you run your tank almost empty then fill it full every time? That's what it sounds like. That's the most ideal way to do it, after all the gas gauge should be accurate..haha.

I hate my gas gauge. I run it till it's almost dry and fill it all the way up, but my E light comes on way, way too early. We have a 15.9 gallon tank and if I fill her up right when the E light comes on, she'll only take about 12.3 gallons.


--------------------
taking too long to mod since '09
June '12 COTM
'95 AT200

516 Pages V  « < 71 72 73 74 75 > » 
Reply to this topicStart new topic
6 User(s) are reading this topic (6 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: November 24th, 2024 - 9:02 AM