6G Celicas Forums

Hey guys I have tanabe df210 springs coming to me right now with kyb gr2 struts but I'm a little concerned. My 6gc wheels and tires are off a 7gc gts wheels and tires... Which are 16" wheels if I'm correct... Now the tanabe df210 says they drop 2.2" front and 1.5" rear. Will my front wheels be hitting my chassis? I measured it but it seems really close and it's not an exact exact measurement so I'm just wondering if anyone else did this kind of drop and will I make it without hitting the chassis? Any pictures?

Thanks
Gerald

You're fine.

Ha....ha.....ha....



hitting chasis......


I wonder when Im gonna hit chasis?





Spolski had the best 6 on Tanabe springs

Hahahaha thanks guys(: just a little paranoid:/ cuz I have springs that hit my 2007 camry SE chassis lol but that's prolly because I had bigger wheels(:

This post has been edited by hizzle369: Mar 28, 2011 - 11:10 PM

Lol, yea. You're gonna have to go a lot lower than that to hit chassis. The Camry was probably just rubbing the fender. So IF anything happens to rub, you probably would just need a small camber adjustment. You can talk to 808Celica or HarolFastwaker about that, or other member who know about camber. Hope you guys don't mind me using your names.


-Ryan

You wont need to run neg camber with that set up, im running very little negative camber with a 2.5 in drop and 25mm spacers and i rub very very rarely on the front fender, back had to be rolled, but thats another story

Have the same suspension/wheel setup in this pic... NO RUB RUB.



You're good.

I rub... But again 2.5 in drop and 25mm spacers

I rub ALL NIGHT LONG.......

ask me anything if you dare

I have come to realize that rubbing is all part of lowered cars lol, and scraping, lots of scraping, but Low is a Lifestyle

HAve you bent a control arm yet you Low Life Son of a.............

Will I be needing wheel spacers for this drop?

Depends on your wheels' offset. Not the drop.

view the pics a few posts up - mine have no spacers, but stgreendemons do.

do your tires wear out fast without the spacers?

That mostly depends on the camber, not the spacers. The spacers just bring the wheels out horizontally. But those springs shouldn't drop it enough to where a normal alignment can't adjust the camber. Even then, there's always camber bolts. But you won't need camber bolts.

This post has been edited by HectortheRican: Apr 7, 2011 - 1:15 AM

Correct

No unusual tire wear from my set up.

Another question popped into mind!

I just had a friend told me that with that large of a drop; 2.2" the KYB Gr-2's might not be able to sustain the shocks. Is that true? Like it doesn't absorb enough causing the shocks to blow...

But I'm guessing Kaos, that you've had the Tanabe DF210s + KYB Gr-2s for a while right?

Also; Will I be needing Bumpstops; is this gonna bottom out? I will be installing tomorrow.

This post has been edited by hizzle369: Apr 12, 2011 - 11:45 PM