6G Celicas Forums

hi, I'm on the half way to replace wheel bearing.
I can't remove the steering knuckle. Any hint?

Removed brake caliber.


How to remove this?


And these?

With 17mm socket and ratchet? I'm not sure what you're asking.

here are your options

a) ball joint separator tool (fastest, easiest way i know of but costs ~$25)


b) 2 or 3-jaw puller (3 jaw is easier to work with, costs ~$10)


c) ball joint separator fork (costs ~$10 but will likely damage rubber boot in the process)


and just fyi, there's already a how-to on this: How To Replace Wheel Bearing (Front)

regarding the need for a press, either you buy one, or just go to a mechanic shop to do it for you. don't use a hammer.

This post has been edited by azian_advanced: Nov 18, 2012 - 8:46 PM

Yeah they're 17mm. But I can't remove them. Used PB blaster but not better.

I missed it. Thanks.

How big of a ratchet are you using? Get a 1/2 inch ratchet with a breaker bar.

Loosen the bolt if you can, then get a breaker bar between the joint and mount. Apply mallet.

Or..just don't remove it there.

Simply mark where the bolt is on the rod with some whiteout, then spin the guy off the rod. Screw taking that point off, its a pain. I always just break the hub loose with the 3 bolts on the bottom, axle removal of course. Then spin it off.

Also, please get some zipties, or metal line to hang that caliper up to the spring. I see it sitting on the box, but you may hit the box, and have the bugger drop busting the break line.

This post has been edited by rave2n: Nov 19, 2012 - 9:31 AM

I don't have a breaker bar but I'll try my 1/2" lug wrench.




Yeah I have a mallet. I'll try a longer bar or wrench.



Thanks for teaching me about these.

This post has been edited by dangqiwu: Nov 19, 2012 - 4:18 PM

All you need is a pipe that slides over the ratchet for a breaker bar.