Antenna Down? Options

[6GCBORO]

Im not trying to remove the whole antenna but i want to get it to go all the way down. mine just stops going down right at the end. someone help please.

[Galcobar]

Best I can figure is that some of the teeth on the plastic track broke off or wore down, so the gear which raises and lowers the antenna mast is slipping on a specific section. Alternately, the track may have gotten twisted inside the motor and is not allowing the mast to drop all the way. The third option, which I consider most likely, is that the top portion of your antenna mast was bent and therefore doesn't fit inside the portion below it.

[rentaspace]

Mine used to do this sometimes too, other times it would go completely down... I got sick of it's looks, opened the internal boot panel, disconnected its power source, then disconnected the antenna and re-routed it to the roof. Bought a $12 Shark-fin antenna, drilled a hole in my roof, fastened and sealed the antenna with Silicone and that is now my antenna

I used to just physically push my antenna down the last bit when it didn't work, but unless you are prepared to break it, don't do this

[trdproven]

if you still want to use radio, then you are stuck until you get a new motor. or switch to s2000 antenna.