FS: headlights, taillights, flywheel from ST205, They're just sitting around Options

[Jeebus]

Here's what I have:

Flywheel from my ST205. $200 obo.
Will fit any North American 3SGTE engine (Celica All-Tracs, SW20 MR2, as well as any ST205 swappers). Came out of my car after the clutch finally blew after 21 years of driving. Engine has 103k miles on it. Reason for selling, I replaced it with a C-One lightweight flywheel.
Yes, you can get OEM replacements for cheaper from other places. I see this as a direct replacement from its birth mother, forged from the deep volcanic caverns of Mt. Fuji from the runoff of Godzilla's hearty meal.



Taillights. $100 for the set.
Although they are from my JDM car, they are DOT approved. There is a tiny chip on the left side taillight, at the bottom of the center lens. Reason for selling them, the safety inspector was going to fail my car for the out of province safety inspection when I imported it unless I replaced it, so I purchased Kouki lights. These lights are in working order.




Low Beam Headlights. $50 ea.
These are USDM housings with JDM lenses transplanted onto them. Not DOT approved due to the JDM lenses. Reason for selling, they are left over from my DOT approved lens swap I did to make my car compliant with my safety inspection. I wanted to keep the extra bulb socket found inside the JDM housing, so I transplanted USDM lenses onto my JDM housing. These are the bastard children of my mod. Use these to make a prototype projector lens (or what have you) for your 6GC without having to destroy your original housing/lenses. All tabs are intact. Gasket and gasket clips not included, as I used them.

High beam housing (Right side, I believe, but will check). $30.
This is only the housing for the high beam. Long story short, again for my safety inspection, it had a chip, and I had to replace my original high beam. When I received the replacement unit, it immediately fell out of my hand when I was taking it out of the box, and the glass shattered. Future DIY project for you!




I will find out shipping prices (with tracking) once interest is gained.

This post has been edited by Jeebus: Feb 10, 2015 - 5:09 AM