just threw in the custom clears! |
just threw in the custom clears! |
Jun 12, 2006 - 8:03 PM |
|
Enthusiast Joined Jun 14, '04 From Buffalo, NY Currently Offline Reputation: 6 (100%) |
here are some pics....quick simple mod...
Edit: ok i resized the pics...sorry again... After: Before: This post has been edited by Theyellowdart084: Jun 12, 2006 - 8:18 PM |
Jun 12, 2006 - 8:11 PM |
|
Enthusiast Joined Mar 25, '06 Currently Offline Reputation: 0 (0%) |
ahh! get a resize... i cant even use my imagination to compare them at that size.
-------------------- ----- '94 ST hatch --- Yellow ----- |
Jun 12, 2006 - 8:16 PM |
|
Enthusiast Joined Jun 14, '04 From Buffalo, NY Currently Offline Reputation: 6 (100%) |
thanks...i just edited it....that last pic was MASSIVE haha....
This post has been edited by Theyellowdart084: Jun 12, 2006 - 8:18 PM |
Jun 12, 2006 - 10:26 PM |
|
Enthusiast Joined Oct 12, '05 From Texas Currently Offline Reputation: 59 (100%) |
very nice, how did you make them look so good? ...did you make them? HOW!!??!! lol...
~snap -------------------- Past: V6 Swapped 6G Celica, E46 BMW M3, Jeep Wrangler TJ
Current: 850rwhp C6 Corvette Grandsport, Gen1 6.2L Ford Raptor |
Jun 13, 2006 - 9:21 AM |
|
Enthusiast Joined Jun 14, '04 From Buffalo, NY Currently Offline Reputation: 6 (100%) |
thanks for the compliment ....i can't really take all the credit on this one, i bought them from celiracer....i PMed him a while ago and asked him how he did it and this is what he said:
QUOTE Hey man. There is a how-to on the forum. But i kinda did a little bit different. First things first i'll try to follow you through it step by step. Things you need. 1. oven 2. fillips screw driver 3. pan 4. freezer I KNOW I KNOW sounds kinda funny. But it works. take the bulbs out of the turns and out of the bumper. turn your oven on 450 degrees. get a pan and place one turn signal onto the pan. Then put the pan in the oven. (NOTE) you want to watch the turn signal as its in the oven. I also don't know how long to keep it in there. But just remember this. (the glue around the housing melts faster then the actual plastic turn signal does) 4. once you think the glue is melted enough pry the clear lense off the plastic housing. then take a screw driver and take the orange block out of the housing. If you hurry you can just throw the clear lense back into the housing and throw it into the freezer so the glue can tighten back up. If it doesn't work that easy then put the housing back into the oven so the glue can heat up again. After that is done do the same thing to the other turn signal. |
Jun 13, 2006 - 4:53 PM |
|
Enthusiast Joined Oct 5, '05 From NE Currently Offline Reputation: 6 (100%) |
Looks good man. now you need to take a picture of your full car so you can see how good it looks with the rest of the car
-------------------- |
Lo-Fi Version | Time is now: December 4th, 2024 - 4:42 PM |