Camber Adjustment, I have a slight problem Options

[y2komar]

I have a 94 gt. Dropped with h&R springs and KYB shocks rear and front.
I took it to get alighned and they said because of the drop the camber is off slighly.
I have the upper mount of the springs with a preset camber adjustment. Is there something else i can do to adjust it better.
What do you guys have.
Even after the alighnment the car still turns towards the right.

[bufferdan]

Get some "crash" alignment bolts to allow camber adjustment

[y2komar]

Get some "crash" alignment bolts to allow camber adjustment

Sorry I dont know what you are talking about?
What is a crash alignment bolt?

How do you install them.

Thank you

[y2komar]

I found this online


These bolts are used for crashed cars that have suspension damage and cannot be returned to stock camber. The bolts are available in three sizes: 1 Dot, 2 Dot and 3 Dot. The part numbers are as follows:

1 Dot 90105-15004

2 Dot 90105-15005

3 Dot 90105-15006

Each successive bolts will change front camber by -0.5 degrees. I used 2 Dot bolts in my car to get close to the camber I wanted, since 3 Dots would give me more than I wanted. The alignment I ended up settling on was as follows:


Has anyone done this?
Then, how did you get the proper alignment?

[playr158]

get a set of CUSCO upper pillow mounts for the front
http://www.japanparts.com/Pic/pic075/058.htm
http://www.japanparts.com/db/partslist.php...er=&volkey=

[Rayme]

Just get the eibach or obx camber adjustment bolt...its basicly bolts with cams on them.



Its what I have and my alignment is all in specs now(mind you I installed the bolt myself using my eyes as aligment! lucky sob).

This post has been edited by Rayme: Jan 3, 2007 - 4:54 PM

[y2komar]

Just get the eibach or obx camber adjustment bolt...its basicly bolts with cams on them.



Its what I have and my alignment is all in specs now(mind you I installed the bolt myself using my eyes as aligment! lucky sob).

Thank you for the help. This is what I found I hope it works well.

IEC-35450 Adjustable Camber Kit, Eccentric Bolts, 17mm, Toyota/Lexus/Pontiac/Scion, Front,

Ingalls Engineering Co
Not all camber kits are created equal!
These adjustable camber kits from Ingalls Engineering have a Posi-Change feature, allowing camber changes up to 3 degrees positive. Each block displays a vertical line above the bushing that represents a 2 degree positive change. Don't trust your wheel alignment to just anyone--Ingalls has been producing camber kits for over 20 years, and you can be assured that you're getting a quality product

[jdg371]

I got a pair of 2 and 3 dots from Toyota for 20 bucks

[trdproven]

Do camber kits work only because they are skinnier bolts and you can adjust the angle? thats what it looks like.