loud fast rattle sound passen wheel when let off gas Options

[illneversellmyce...]

about 3 wks ago installed cross drilled slotted rotors and ceramic pads, was fine at first, week later it started making a horrbile screaching noise, had it checked out the brake clips were old and hitting the rotor and grinded away, so orderd new clips, once again no problems for a week. but now when i let ofthe gas it sounds like my rotor is not tight? and hitting the caliper bracket who knows,...anywy its annoying as hell.
well i jsut read the bent luck thread and i did hit a deer last year, guess i need to check to see if my a frame and ball joint are toasted.

any one have any suggestions i'm pretty sure when i was working on the caliper i tightened the 15mm bolts that atttach the caliper bracket to the rotor pretty good, could i have not tightened it enuff

this problem comes and goes

any sugestions would be apprecaited

This post has been edited by illneversellmycelli: Jan 24, 2007 - 12:36 PM

[LewFX]

try the bearing, make sure its rotating straight

[illneversellmyce...]

anyone second lewfx's motion? I probally go by the shop and have them check the bearing

[LewFX]

did you resurface the rotors since the clips were touching them?

[illneversellmyce...]

yes that rotor had to get spun like 3 times or so

did you resurface the rotors since the clips were touching them?