Grease gan hoses - temp ratings, Oil pressure sensor relocation |
Grease gan hoses - temp ratings, Oil pressure sensor relocation |
Feb 7, 2007 - 4:49 PM |
|
Enthusiast Joined May 2, '06 From Nevada Currently Offline Reputation: 0 (0%) |
Autozone, Pep Boys, etc have 6.99 grase gun hoses - very high pressure,
1/8 npt - can they be used to relocate oil pressure sensor? Anyone tried those with hot oil - how they stand to it? If they do - it would be a good deal as opposed to braided NOS lines (pricewise). V |
Feb 7, 2007 - 5:01 PM |
|
Enthusiast Joined Apr 28, '04 From Houston, Texas Currently Offline Reputation: 2 (100%) |
I'm a lubrication engineer and I have one of these in my office right now. Looking at it I'm 100% sure it would hold up to the pressure but I don't think I would put that line anywhere near my turbo or header due to the heat. IDK - if you had a oil pressure gauge hooked up and could monitor it while driving and test this out you could just shut the engine off if a problem arose. IMO - I wouldn't try it. Just spend the extra money and wait the extra time to do it right the first time. Personally I use Pressure2's setup as a guideline and try to stick with his results. I'm not gonna cheap out on something as important as oil - the lifeblood of your engine/turbo.
This post has been edited by Negative: Feb 7, 2007 - 5:03 PM -------------------- |
Feb 7, 2007 - 8:35 PM |
|
Enthusiast Joined Aug 9, '06 From Ma Currently Offline Reputation: 1 (100%) |
Why do you want to change the location of the pressure sender?
It's in a easy accessible place.... -------------------- |
Lo-Fi Version | Time is now: November 26th, 2024 - 4:14 PM |