i need help (3sgte swap) Options

[RUNNIN-LOW]

the two plugs i dont know where it goes anymore?

the throttle cable where do i mount it at?

another picture of my cable

the last 2 vaccuum hoses that im not sure what goes into it..

so yeah 3sgte swap people can yah help me get this stuff straight...thanks

This post has been edited by RUNNIN-LOW: May 4, 2007 - 9:01 AM

[Supersprynt]

Seems as though your missing the mount that goes on the throttle cable. Might wanna check the Alltrac forums for that part.

Those 2 vacuum hoses look like they should go to the charcoal cannister, but its been awhile since I messed around with them.

This post has been edited by Supersprynt: May 4, 2007 - 9:30 AM

[x_itchy_b_x]

nice 3rd gen!

[lagos]

the black plug on the right goes to your coil. the vac lines go to your ac idle up stuff. you can put a vac cap over them . your also missing the throttle bracket, factory catch can, as well as your coil, from what i can see. you might also want to clean all the rust off that igniter bracket or get a new one, because your car might not run if that bracket is not bolted to a good ground, or has that much rust on it.

This post has been edited by lagos: May 4, 2007 - 10:07 AM

[phattyduck]

Your pictures aren't showing up for me... but this might help you a bit:



This is the clip I used for my swap before I bought it. If the pictures show up for me, I can help you out some more...

-Charlie