need major engine help please Options

[trackdaydavid]

the bottom end on my 3sge st202 started to make a rattling noise and about 3000 rpm so i bought a new bottom end and had a so called garage fit it into my vehicle, when they have come to put all the vacuum pipes on the rebuilt engine they haven't got a clue where they go but put them where they think they should be and have also broken a few of the sensors which i replaced with off another motor but the car will not idle, stalls, when accelerating makes a constapated type noise and won't accellerate over about 10 mile an hour. been back to them and said nothing they can do don't know enough about the vehicle to fix it even though i have paid them, contacted citizens advice and been told best to try to talk to them first. Can anybody please give me a diagram of where all the pipes from inlet manifold, purge canister and the likes comes from and goes to so i can try to put it back together. Please help or i will have to break up the car and scrap it as spent well then more than than the car is worth on labour only. please help to give life back to my car any help would be appreciated as i got a toyota data manual but that doesn't show any real pipe runnings

[Mstoochn]

the bottom end on my 3sge st202 started to make a rattling noise and about 3000 rpm so i bought a new bottom end and had a so called garage fit it into my vehicle, when they have come to put all the vacuum pipes on the rebuilt engine they haven't got a clue where they go but put them where they think they should be and have also broken a few of the sensors which i replaced with off another motor but the car will not idle, stalls, when accelerating makes a constapated type noise and won't accellerate over about 10 mile an hour. been back to them and said nothing they can do don't know enough about the vehicle to fix it even though i have paid them, contacted citizens advice and been told best to try to talk to them first. Can anybody please give me a diagram of where all the pipes from inlet manifold, purge canister and the likes comes from and goes to so i can try to put it back together. Please help or i will have to break up the car and scrap it as spent well then more than than the car is worth on labour only. please help to give life back to my car any help would be appreciated as i got a toyota data manual but that doesn't show any real pipe runnings

www.toyodiy.com

they should not of done the rebuild.

This post has been edited by Mstoochn: Jan 14, 2010 - 1:38 PM

[trackdaydavid]

thanks for that but ideally i really need an engine bay picture or the likes of where all the hoses and sensors go if anybody can help. checked rotor, dissy, plugs, leads and the simple stuff. i really think the small breather pipe on the purge valve is wrong as there is too much hose left over and i remember it being really quite tight and almost stretched to start with. thank you for your help. any ideas would belp as it looks like i'm on my own with this one.