shaHow many of you used the 91 camry V6 outter shaft for your hybrid a Options

[celi_booster]

I have a 94 Celica GT and planning on doing a 2nd gen 3sgte swap with the E153 tranny. I was looking through the forums and found many of the guys using ST185 outter shafts with spacers and some guys go with the 91 camry V6 outter shafts. For the 91 camry V6 outter shafts, do we need spacers?

Stupid computer messed up my topic title. It was supposed to be How many of you used the 91 camry V6 outer shafts for your hybrid axles?

This post has been edited by celi_booster: Mar 28, 2011 - 2:57 PM

[Culpable04]

the spacers for the axles will depend on your setup / ride height etc.

I know Corey was using Camry outers and he needed spacers, then some people have ST185 outers and need spacers, I havent need spacers, I was ready and prepare to put them in, but after everything was set and done, I didn't need them, it seems to depend on what ride height you set your car to. my car is not a special case, there are a few other guys here with the same exact setup I have and they haven't need spacers either. so it varies a lot.

[presure2]

Yea, it really is a case by case basis.
Jim has had 3 different e153 trannys in the car, (mr2, es300, mr2 w/LSD) and none of them used a spacer with the mr2 inners, and alltrac outers.
Dustin on the other hand has spacers on both sides. (iirc camry e153, mr2 inners, alltrac outters. )

[celi_booster]

I hope I am the lucky one that doesn't need spacers. If I'm going with the 91 Camry outers, do I get the front or rear outers? I notice they're different in lengths...

[Culpable04]

fronts