projectors modification Options

[hzawde]

is it necesary to modify them once you have them , or can i just directly replace them, i doubt everyone with them
has done the mod for lhd use

[Timmyface]

It depends on a few things:
You may, blind the opposite side of the road resulting in a crash, or a fine off police.
It will help you see better on the road, but its more for safety reasons. If your not running HIDs you could get away with it probaby.

[mkernz22]

you could also just make them point a little bit lower too

[hzawde]

ill do the point thing probably, looks too intense to do the whole mod thing

you could also just make them point a little bit lower too

[RoyO]

In the Netherlands, we have to convert them to LHD to be road-legal, so that's the main reason why I converted them.
Modification is easy but it just takes some time. Here's a short how-to of my conversion.

My new projectors


Take off the lights and all rubber parts.


Put them in the stove: 10 minutes at 120 degrees Celsius



Take off the glass


The part of the projector that has to be converted




Cutting the metall. I used a DREMEL with a grinding wheel.


Re-install the projector. Put it back into the oven so the glue becomes soft again > it's easier to re-install the glass.


I used this glue


The result





I installed Pilot HID, H1 6000 in lowbeams, HB3 6000K in highbeams and H3 6000K in the foglights.

-Roy

This post has been edited by RoyO: Dec 26, 2011 - 5:09 AM

[hzawde]

ok thanks a lot man, really helpful