KYB GR-2 SHOCKS, I know we use struts so... Options

[Jeremy1210]

I know that our celicas use struts. These are on ebay KYB GR2 Shocks

I am looking for good quality suspension and I have read on here that KYB's are really good. My question is; Are these what I am looking for? I'm not sure because it says shocks and we use struts.
Any help appreciated

Jeremy

[Coomer]

We use a combination of shocks and struts. In the front, you change the shocks and use the stock strut assembly, and in the rear, you get whole struts from KYB that replace the entire strut assembly.

[96stcoupe]

I think they are cheaper than that on tirerack.com

[Cormudgen]

same price or maybe $5 more. so many people have posted about this guy's acution before(he keeps relisting b/c he is askign to much) i know i personaly would just buy them from www.tirerack.com for the added security

cormudgen

[macavely]

yea order them from tirerack i got mine in 3 days and the up dated my every step of the way..

[khanster]

dude the thing called shocks are for the rear of the vehicle. struts are for the fronts. lol

[toyotaspeed_90]

if you're looking for a good stiff strut for a good stiff set of springs the gr2's aren't the way to go.... my 1.5" drop (90 corolla) the struts are too tall and too soft, though i'm guessing they're the only thing giving me a halfway decent ride.... the camber plates made the car quite rough

[SpedToe169]

[Kwanza26]

[Jeremy1210]

so If I was to lower my car, Go with Koni's then?

[Kwanza26]

[R-03]

you can replace the whole strut assembly or buy the strut refills. i replaced the whole thing it's a little easier, took 20 min. to do both (front), but i would recommend you replace the strut mounts also. the refills are cheaper, it is just the tube with the piston. the pack comes with a threaded washer that locks the tube inside the strut housing. you have to take the spring off like always, then the rubber boot, there is a nut on the top side. clamp the strut, not too tight, then use a pipe wrench to take the nut off (left hand thread) watch for the fluid that will pour out. take out all the washers and pieces from the housing. then pour the recommended cc of trans fluid into the housing, slip in the tube, then cap with the threaded nut. that's it. by the way 5cc's=1tsp. it's not hard either just takes a few min. longer, but it is cheaper. sorry for the long post. if you want to do this and need help, let me know.

[Jeremy1210]

I was thinking of buying the Eibach springs that lower the car an inch. Then some new struts.

[Kwanza26]