Going for a 7AFTE, What do i all need?? Options

[onnaj]

Hello,

I was about to supercharger my car, but i changed my mind and want to go for turboing my car. I don't want to any higher then the 8 psi @ which the wastgate is set

I've got myself a nice package already, which contains the following:
1) Exhaust manifold for T3
2) T3/T04 hybrid turbo
3) Universal extarnal wastgate (set @ 8 psi / 0.55 bar)
4) HKS Blow-off Valve
5) Oil feed (with restrictor) and return line
6) SARD fuel pressure regulator (is boost dependant -> gives higher pressure when boosting and lower when not boosting)
7) 4AGZE injectors or are they overdone? I do have some Silvertop/Blacktop injectors but don't if they'll fit.

What do i need more to complete this project?
I think i might need the following:
1) Downpipe but cannot find one yet
2) 2 BAR MAP sensor?
3) FMU 12:1 is this necessary?
4) FMI, maybe using the stock 4AGZE intercooler, would that be sufficient?
5) Change the timing a little to about 8 to 9 BTDC?
6) Air fuel gauge
7) Boost pressure gauge

Can i make it work (at first) without a piggyback hooked up? I'll go for this later on.

Do i need a BOV? I think it sounds ricey, so i prefer not mounting it.

thanks for all your advices!


Pictures:

[Syaoran]

You're missing the most important part: a tuning solution. Bigger injector and boost-referenced FPR is not the correct way to go. It's good stuff to have but you don't need either the FPR or the 12:1 FMU if you get at bare minimum a piggy-back ECU. Don't leave it for later on, it might be too late then.

AEM FIC, GReddy e-Manage Ultimate are two good ones.


If that's an eBay wastegate I have a tip for you: put red loctite on the threads of every vacuum nipple, they tend to back out and that makes the wastegate stay sealed shut. As for everything else, they work just like any other wastegate.

You don't need a BOV, a lot of cars have come without BOVs in the past and they haven't blown up like everyone would suggest. However no BOV will sound even louder than using a BOV. If you want to reduce noise, recirculate your BOV back into your compressor side. Mount the HKS BOV with the recirculation port and route a hose to a nipple on your compressor's intake (you'll have to get it welded)

[Smaay]

You don't need a BOV, a lot of cars have come without BOVs in the past and they haven't blown up like everyone would suggest. However no BOV will sound even louder than using a BOV. If you want to reduce noise, recirculate your BOV back into your compressor side. Mount the HKS BOV with the recirculation port and route a hose to a nipple on your compressor's intake (you'll have to get it welded)

worse advise ever! i dont know of any factory turbo car that does not have some sort of recirculation to relieve pressure in the system.