Operation: DARKSPYRO, AWD Conversion, Completed. Driven. Sold. Options

[Malek]

Mission: Do it right the first time

Phase 1:
-Gen 3 3sgte swap

Phase 2:
-Complete AWD conversion
-Clean


28 JAN 13
Purchased 1999 Toyota Celica from a private seller in Boulder, CO.
Apparent timing issue and suspected head gasket issue.
Drove it 30 minutes back to Golden, CO with coolant spewing. And when I got back, I beat on it some more.
Back at the shop, wasted no time tearing into it

Had to stop once to let it cool down a little


Ripping into it that night



29 JAN 13
Engine and transmission pulled

Signature Tweak pose


31 JAN 13
Ordered ST205 front clip
-coming with bumper, fenders, hood, lights and a set of projectors
-rear subframe
-rear diff, axles, brakes, drive shaft
-Ton of extra stuff I don't need






1-9 FEB 13
Ordered:
-Berk gen 3 downpipe ceramic coated with wideband bung
-Clutchmasters FX300 assembly for swap
-Triple gauge A pillar (for boost, oil press, wideband)
-Hose for remote oil pressure sender location
-Walbro gss342 + 400-765 kit
Cut a hole in the fire wall for wiring harness

9-15 FEB 13
-Have been collecting parts for the swap
-Installed new Walbro fuel pump

17 FEB 13
-Final decision has been made
FULL AWD Conversion
-I plan on using the GT suspension and GT4 brakes
-Have not decided yet to cut floor pan and weld or make custom brackets


ETA for clip 11 MARCH 13
Until then, I will be researching boost controllers and wheels.

11-18 March 13
PHASE 1: COMPLETE
see page 2
-3rd Gen 3SGTE
-FWD
-OZ Crono

30 April 13
PHASE 2: BEGINS
see page 3 and 4
-Fuel Cell
-AWD
-GT4 Brakes

This post has been edited by Malek: Jan 28, 2018 - 3:53 PM

[Malek]

OK, so let's get into more of the details here.

We're talking full conversion.
E154F with axles
Super Strut, hubs, brakes
driveshaft, rear diff, gas tank.

what the hell, might as well do GT4 gauge cluster and auto climate control swap while I'm at it. Should be pretty easy since I am keeping it LHD. I'd just need to swap out interior harnesses right?? I know the auto cc has 3 sensors and I'd need to swap the 3 fan assembly but as far as the GT4 interior harness, it should fit with quite a bit of extra slack right? Correct me if I'm wrong on that..

AWD conversion:
I plan on dropping the engine and transmission in and getting everything bolted up and connected (As if it were a normal swap). Swapping out the front axle, hub, and strut assembly as one unit, if I can haha From there, I plan on starting from the transmission and working my way back making sure the brackets for the drive shafts are straight and strong. And when I get to the rear, I'll need to figure out just how much of the GT4 floor pan I will need to cut and transfer over. I'm hoping it's just the trunk area but that will most likely not be the case.

Well, damn..no longer need that hybrid clutch haha