Operation: DARKSPYRO, AWD Conversion, Completed. Driven. Sold. Options

[Malek]

Mission: Do it right the first time

Phase 1:
-Gen 3 3sgte swap

Phase 2:
-Complete AWD conversion
-Clean


28 JAN 13
Purchased 1999 Toyota Celica from a private seller in Boulder, CO.
Apparent timing issue and suspected head gasket issue.
Drove it 30 minutes back to Golden, CO with coolant spewing. And when I got back, I beat on it some more.
Back at the shop, wasted no time tearing into it

Had to stop once to let it cool down a little


Ripping into it that night



29 JAN 13
Engine and transmission pulled

Signature Tweak pose


31 JAN 13
Ordered ST205 front clip
-coming with bumper, fenders, hood, lights and a set of projectors
-rear subframe
-rear diff, axles, brakes, drive shaft
-Ton of extra stuff I don't need






1-9 FEB 13
Ordered:
-Berk gen 3 downpipe ceramic coated with wideband bung
-Clutchmasters FX300 assembly for swap
-Triple gauge A pillar (for boost, oil press, wideband)
-Hose for remote oil pressure sender location
-Walbro gss342 + 400-765 kit
Cut a hole in the fire wall for wiring harness

9-15 FEB 13
-Have been collecting parts for the swap
-Installed new Walbro fuel pump

17 FEB 13
-Final decision has been made
FULL AWD Conversion
-I plan on using the GT suspension and GT4 brakes
-Have not decided yet to cut floor pan and weld or make custom brackets


ETA for clip 11 MARCH 13
Until then, I will be researching boost controllers and wheels.

11-18 March 13
PHASE 1: COMPLETE
see page 2
-3rd Gen 3SGTE
-FWD
-OZ Crono

30 April 13
PHASE 2: BEGINS
see page 3 and 4
-Fuel Cell
-AWD
-GT4 Brakes

This post has been edited by Malek: Jan 28, 2018 - 3:53 PM

[Malek]

11-18 MARCH 13
I took delivery of the package!


And again, I went straight to work on getting it all out and in




That size difference


Got some help


Got her in! (This pic was right at start up. I tidied up the wires and stuff. Don't worry haha)


At this point, I was having a fueling issue. I ran a 12ga wire and relay for the pump thinking it just wasn't getting enough current.
Turns out the fuel pump resistor pack wasn't completely plugged in.

Still have to fix that little gap


Finished!


References used:
-Pump wiring by Lagos
-3SGTE wiring explained
-Wiring by Manny

Phase 1 Debrief:
-I ended up pulling the frame over the 3sgte engine. Rear output shaft housing kept getting stuck in between the subframe and steering rack.
-Missed the sneaky fuel return line to the gas tank. Spewed gas all over the floor on first start up
-Fuel pump resistor pack wasn't completely plugged in. Ran for 20 seconds and then died. Plugged in now. Works.

Upcoming:
-Until Phase 2 begins, I will be focusing on cleaning everything up, exhaust, tuning, wheels, and suspension.

Stay Tuned!