6G Celicas Forums

Welcome Guest ( Log In | Register )

> 95 Celica 7AFE won't start, Turns over normal just won't start
post Mar 24, 2013 - 4:12 PM
+Quote Post
kevinf

Enthusiast

Joined Mar 24, '13
From Denver, CO
Currently Offline

Reputation: 0 (0%)




Hello,

I have a '95 Celica ST auto with the 1.8 liter, 177k miles. Car is completely stock, well maintained, and has run with no issues until now. It drove normally until a couple weeks ago while driving it all of a sudden, at low speed, sputtered a little then died and would not restart. It turns over normally (not fast), just won't start. The gas light had just come on, so I tried putting another gallon of fuel in to no avail. I towed it home and have been troubleshooting since but I'm stumped.

What I've done:

Checked for spark: spark is there, but not "bright blue" like the Chilton says it should be. Was more orange/blue.
- replaced plugs (gapped to 0.31)
- tested wire resistance - less than 10k ohms so OK.

Distributor cap posts had a thin white crust on them, and rotor looked 'burned', with a thin black layer of crust and well worn
- replaced cap and rotor
- signal generator resistance G+ to G- = 214ohms, NE+ to NE- = 424ohms (both in spec)
- ignition coil Primary Resistance (+ to -) = 1.7 ohms, Secondary Resistance (+ to terminal) = 11.4ohms (both in spec)

I looked to check the Crank Position Sensor resistance but this engine/year does not appear to have one.

- Fuel pump primes when jumping the +B and FP terminals, as well as when attempting to turn over.
- fuel inlet pipe feels like it's getting pressurized when jumping fuel pump

- Timing belt was changed 30k miles / 3 1/2 years ago.

At this point, the only thing left I can think of is:
1) test fuel pressure -- I'd have to borrow a gauge
2) compression test -- also need a gauge, although I highly doubt something internal broke as the car has run perfectly up until now

Is there something I'm missing? Should I just try replacing the ignition coil and/or distributor?

Thanks



--------------------
 
Start new topic
Replies
post Mar 24, 2013 - 11:53 PM
+Quote Post
Box



Enthusiast
*****
Joined Feb 23, '12
From Warrior, AL
Currently Offline

Reputation: 0 (0%)




Usually the distributor being bad will throw a code 12. Perhaps the ignition coil. Something similar happened to my dad's 4-Runner. Was running fine the died suddenly and wouldn't start. Had weak orange spark like you mentioned, ended up being the ignition coil.


--------------------
2001 Miata LS 5-speed
post Mar 25, 2013 - 8:16 AM
+Quote Post
rave2n

Enthusiast
*****
Joined May 29, '09
From Gainesville, FL
Currently Offline

Reputation: 17 (100%)




QUOTE (Box @ Mar 24, 2013 - 11:53 PM) *
Usually the distributor being bad will throw a code 12. Perhaps the ignition coil. Something similar happened to my dad's 4-Runner. Was running fine the died suddenly and wouldn't start. Had weak orange spark like you mentioned, ended up being the ignition coil.


His vehicle will not throw a code being ODB1

Atleast my ST did not when my distributor when bad.

If you are in need, I believe I have a ST distributor from my old one that was put in to replace the one that went bad. When mine went bad, car would stall. Turn over occasionally, but if you hit the gas, it would die quickly. Indicating timing issue, which was oil leaking into my distributor.

I'd confirm fuel pressure first like you have indicated. Not positive its distributor.

This post has been edited by rave2n: Mar 25, 2013 - 8:20 AM

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: December 2nd, 2024 - 1:58 PM