ST205 Powered ss3 Coupe, "ST205 Powered Coupe!!" continued.. Options

[Ted95]

Hey guys I’m creating a new thread over in the “My Project” section as it seems more fitting now..

3s swap..
http://www.6gc.net/forums/index.php?showtopic=75890

The car has kind of been ghost for a while, haven’t posted much of the recent work/progress I’ve done over the past year. I’ve been picking away at it between work and school.. so there will be lots of various pics!

November 2012-

Earlier in the year, July 2012 I had most of the body work done when my Comp clutch spit out a spring on me and I didn’t touch the car until November.. pics of the clutch





I then replaced the clutch with a Clutchmasters 6puck unsprung setup..




At this point I haven’t driven the car daily since Oct. 2011 I just put the car in sealer so I could drive it around a bit before winter hit..




Slapped on the GTS wheels and put her on the road





Then a short while later had the same issue that Jesse had with a snapped disk hub.. didn’t actually drop the tranny until March 2013

March 2013-





Scrapped the crap out of the Flywheel too






Did some homework and made a few phone calls and placed an order to Southbend and picked up a 8puck sprung setup with a F1 lightweight Flywheel.. the guys at Southbend were GREAT to work with, highly recommend them, John over in imports was very helpful in creating this setup..








^^ The springs are incased very well and were rubber coated for what I’m told a longer life span and easier ingagement..





Spring April/May 2013

Rolled the front and rear fenders with hammer and dolly, came out really well with no fender warp like some rollers can do.. also did some more fine tuning with getting the ss3 kit mounted, making sure they all fit properly (don’t mind the tape lol)







I chose not to drill holes in the body incase I wanted to take the skirts off at some point, will be using double sided tape but do have holes drilled underneath to support the bottom of the skirts.

And that’s where she is as of right now.. this past weekend I finished up the Hiro rears and fiber glasses the mounting studs in and primed them up.. looking to start wet sanding either this week or next with 500 grit and shoot some color on her, pretty pumped!

This post has been edited by Ted95: Jun 15, 2013 - 8:18 PM

[playr158]

progress coming along well bud