![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Jan 26, '09 From Los Angeles Currently Offline Reputation: 1 (100%) ![]() |
Mission: Do it right the first time
Phase 1: -Gen 3 3sgte swap Phase 2: -Complete AWD conversion -Clean 28 JAN 13 Purchased 1999 Toyota Celica from a private seller in Boulder, CO. Apparent timing issue and suspected head gasket issue. Drove it 30 minutes back to Golden, CO with coolant spewing. And when I got back, I beat on it some more. Back at the shop, wasted no time tearing into it Had to stop once to let it cool down a little ![]() Ripping into it that night ![]() 29 JAN 13 Engine and transmission pulled Signature Tweak pose ![]() 31 JAN 13 Ordered ST205 front clip -coming with bumper, fenders, hood, lights and a set of projectors -rear subframe -rear diff, axles, brakes, drive shaft -Ton of extra stuff I don't need ![]() ![]() ![]() ![]() 1-9 FEB 13 Ordered: -Berk gen 3 downpipe ceramic coated with wideband bung -Clutchmasters FX300 assembly for swap -Triple gauge A pillar (for boost, oil press, wideband) -Hose for remote oil pressure sender location -Walbro gss342 + 400-765 kit Cut a hole in the fire wall for wiring harness 9-15 FEB 13 -Have been collecting parts for the swap -Installed new Walbro fuel pump 17 FEB 13 -Final decision has been made FULL AWD Conversion -I plan on using the GT suspension and GT4 brakes -Have not decided yet to cut floor pan and weld or make custom brackets ETA for clip 11 MARCH 13 Until then, I will be researching boost controllers and wheels. 11-18 March 13 PHASE 1: COMPLETE see page 2 -3rd Gen 3SGTE -FWD -OZ Crono 30 April 13 PHASE 2: BEGINS see page 3 and 4 -Fuel Cell -AWD -GT4 Brakes This post has been edited by Malek: Jan 28, 2018 - 3:53 PM -------------------- |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Jan 26, '09 From Los Angeles Currently Offline Reputation: 1 (100%) ![]() |
After a bit of wrestling, mild cursing, and multiple sanity checks, I have successfully re-mated the 3S to the E154.
-Brand new Clutchmasters FX350 disk and throwout bearing (I will not f***ing give them anymore business, ever. Awful customer service) Tomorrow: -Drop new assembly back into the engine bay -Start on rear end work Sidenote: My UPS delivery guy, Dustin, is the man. I left a note for him at the shop where I knew my clutch would be delivered. He called me up and said he'd swing by my house later and drop it off for me. He knew where I lived because he's seen my car parked in the driveway a few times. He's got a built WRX hahaha Anyways, carry on... -------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: April 21st, 2025 - 4:31 AM |