![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Mar 8, '12 From Hanford/Fresno, Ca Currently Offline Reputation: 20 (100%) ![]() |
So I noticed my fog light looks a bit off. Took them off and looked at them closer. They have some rock chips on them. I was thinking about taking it off and wet sand it starting from 600, 800, 1000, 1500, 2000, and finish it off with 2500 or 3000 grit. What I need help is what kind of polish and uv sealant spray should I use afterwards? I just want to make sure I'm using the correct chemicals and not harm my fog lights too much.
-------------------- |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Mar 8, '12 From Hanford/Fresno, Ca Currently Offline Reputation: 20 (100%) ![]() |
Yea I was using 320 grit for 15 min with minimal results so I just gave up and finished it off. Since its just fog lights I decided to leave them alone. Not like someone going to get on their knees do look at my fog lights. Lol. My car is low so it'll get chipped again eventually anyways.
-------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: February 21st, 2025 - 3:59 PM |