 2nd 3sgte engine tearing it down and putting it back together, the good the bad... the ugly? |
 Jul 15, 2013 - 9:43 PM
|
 
|
 Enthusiast  Joined Aug 12, '07 From Lancaster, Pa Currently Offline Reputation: 35 (100%)  |
so as manny and mr. thoma know i was getting a paint quote on sunday. on my way home my celica shut off and will not start again. timing belt is good. cams look fine. i have no compression in one cylinder. smells burnt im gonna guess bad pisons/rings until i pull it all apart. i am planning on pulling my engine out. i have another lomg block on a stand that i want to rebuild. i am curious as to what engine gasket overhaul kits are a go and which ones are... not so much. i work at a toyota dealership and i understand you get what you pay for, but dont really wanna take a mortgage out to rebuild an engine. couldn't find anything from beck arnley... just looking for thoughts on kits that are good. words of wisdom are welcomed too. please and thank you.
This post has been edited by garin: Jul 18, 2013 - 8:40 PM -------------------- |
 |
Replies
|
Jul 16, 2013 - 9:59 PM
|
|
 Enthusiast Joined Aug 31, '02 From Philadelphia, PA Currently Offline Reputation: 8 (100%) |
Your jdm vin won't do you any good as microcat can't read jdm vins. Just tell the guys in your parts department to look under 90 Celica, and filter the chassis for ST185. All of the parts are the same as what came in the Celica Alltrac.
Sadly aftermarket gasket sets suck for Toyotas because they try to replace half the stuff with paper gaskets that fail after just a few months. You probably don't need a whole gasket set besides the head gasket. Joe and I replaced most of the stuff with OEM gaskets. You should also be able to reuse the timing belt as its also OEM and was done by us just a few years ago. This post has been edited by lagos: Jul 16, 2013 - 10:02 PM -------------------- 15PSI - 30MPG - Megasquirt Tuned
|
Posts in this topic
garin 2nd 3sgte engine tearing it down and putting it back together Jul 15, 2013 - 9:43 PM
presure2 dont go aftermarket.
oem is the way to go for a ga... Jul 16, 2013 - 5:20 AM
garin I'm grabbing my jdm vin plate and taking it in... Jul 16, 2013 - 10:54 AM garin i have another long block im gonna use. i figured ... Jul 16, 2013 - 10:05 PM lagos He doesn't need the vin. I worked for over a y... Jul 16, 2013 - 10:13 PM Syaoran Hope my crappy paper gaskets don't take a ****... Jul 16, 2013 - 10:47 PM lagos QUOTE (Syaoran @ Jul 16, 2013 - 11:4... Jul 16, 2013 - 10:52 PM Syaoran QUOTE (lagos @ Jul 16, 2013 - 11:52 ... Jul 17, 2013 - 2:42 AM garin i went with a toyota engine gasket kit, water pump... Jul 18, 2013 - 8:35 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 26th, 2024 - 6:23 PM |