3SFTE A/F Ratio advice Options

[digs]

Hi, can I ask those who have had experience in this what kind of ratios they expect to see runnning their 5sfte or 3sftes?

I have a wideband, which fluctuates around 14.2 to 15.3 at idle, and 13.5 - 15.1/2 ish off boost runs. The AEM wideband gauge does continually fluctuate though, going through various ranges constantly.

I did do boost run to see, and was measuring 12-13s on WOT. Only 2 runs as not sorted det cans yet so not monitoring detonation. No more boost runs till I work on that.

This is using 295cc injectors, stock pressure. I do have 460cc injectors available too, as well as an afpr, and have emanage blue fitted.

What is the expected values and also, should my wideband be CONSTANTLY fluctuating ? As I will have issues with street tuning as it is never on one value for long ? Or do you guys look for a range?

Any experience would be gratefully received and listened to.

This post has been edited by digs: Jul 22, 2013 - 3:27 AM

[delusionz]

I think you should be using the adjustable fuel reg anyways for its rising rate.


I'm not sure how the emanage works, I'm guessing it uses its own map sensor and it works by constantly feeding garbage to the stock ecu with +/- corrections

So if you increase your fuel supply, then take off from emanage you will reduce fuel but increase ignition as you hit a lower loadpoint on the map. Perhaps reduce your distributor advance a bit, in diagnostic mode set 8 deg advance