![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Aug 25, '08 From England Currently Offline Reputation: 1 (100%) ![]() |
I was certain I started a build thread on here, but for the life of me I can not find it so forgive me if I start again and its old news.
About a year and a half ago my current GT4 failed its yearly inspection (MOT) with rusty sills, they were fixed and it subsequently passed but it set alarm bells ringing in my head that the poor things days were numbered. I decided that I would buy a shell and swap everything onto it. so I hunted for a reasonable shell to start work on. While I was looking, I had to extend my garage. I only had a single car garage so not enough space to work or store stuff. So I decided to extend my garage backwards a bit Work started. ![]() and after a few weeks, finished ;0 ![]() ![]() About the same time a shell turned up, well it was sold as a shell, but it was more or less a complete car minus the engine and gearbox. ![]() ![]() ![]() It was in good condition with no rust, even the interior was in pretty much spot on condition, not that I need much of it ![]() ![]() I set to wrok more or less straight away ![]() First job was to strip everything off the car ![]() everything went, all the looms, glass, suspension the works ![]() Next job was to remove the sound deadening material ![]() ![]() it then went outside for a thorough jet wash go get rid of all the years of crap ![]() ![]() As I was moving the battery to the inside I could remove the battery tray ![]() which I did ![]() ![]() Next up I needed to get to the bottom of the car....this was going to require some ingenuity. -------------------- |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Aug 25, '08 From England Currently Offline Reputation: 1 (100%) ![]() |
Still removing paint and underseal......sigh. Just the fiddle bits left to do which is no fun at all.
Beginning to wish I had a compressor and sand blaster. ![]() As you can see there isn't a great deal more on the GT4 than the normal celica for the rear sub frame. For those wishing to do a proper GT4 conversion you should be able to get the extra bits to weld to a non GT4 to allow for fitment of the rear subframe. Would need looking into it in a bit more detail just to make sure there isn't any hidden parts, but it shouldn't be a difficult task. It would make it as close as possible to a GT4 without buying one. I can check part numbers for those wishing to investigate. ![]() As you can see, I don't have much room to work in ![]() This post has been edited by Nial: Sep 30, 2013 - 3:13 PM -------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: August 18th, 2024 - 11:55 PM |