 can't find radio wire harness :( |
 Oct 15, 2013 - 9:07 PM
|
 
|
 Enthusiast  Joined May 13, '06 From Kaimuki, HI Currently Offline Reputation: 10 (100%)  |
Long story short...I put gauges and switches where my radio goes after I built my engine..and I've been driving around for months with no radio, I just made a bracket to mount it underneath the passenger dash, and now I can't find the radio harness. I'm thinking it fell down and is now under something when I had half the dash out. The only open plug I could find was the one in the picture below, which doesn't plug into the factory radio. If this is for the radio then it might be a disconnect point farther down. I'm kinda lost.
Can someone tell me what this plug goes to if not the radio, or at least show me a picture of their radio harness connector? 
-------------------- -Jay
95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other 01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished 02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve |
 |
Replies
|
Oct 15, 2013 - 9:37 PM
|
|
 Enthusiast Joined Jan 26, '09 From Los Angeles Currently Offline Reputation: 1 (100%) |
Word of warning..
It's kind of a b*tch to pull the plugs on the amp without taking that lower surround off.. It's doable..but it sucks.. -------------------- |
Posts in this topic
match220 can't find radio wire harness :( Oct 15, 2013 - 9:07 PM
njccmd2002 Lol that is your radio harness. It's amplif... Oct 15, 2013 - 9:15 PM match220 Thank you both..Good to know, I'll check that ... Oct 15, 2013 - 10:50 PM
match220 It's all good now, I guess when I put everythi... Oct 18, 2013 - 6:35 PM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: December 4th, 2024 - 6:09 PM |