How can valve clearances get TIGHTER since rebuild??? Options

[Dudleydaftdog]

Hey all, just wondered please if someone could help me get my head round this...

After rebuilding my st205 head and working to Toyota spec (0.15mm - 0.25mm inlet / 0.25mm - 0.35mm) all of a sudden the head developed a loud knocking and a leak at the crank seal... After checking all of clearances (forged rebuilds now done 2000 miles) no1 cylinder exhaust valve nearest the cam pulley has shrunk to 0.20mm!!!. After turning the crank by hand it gets harder to turn as this valves opening...

I rebuilt the head with JUN valves and springs and HKS 256 cams. All was in spec after the rebuild. Thought clearances opened up as the engine broke in not got tighter! The engine was stone cold (left overnight) when I checked. The head was also proffionally rebuilt...

Could this be a worn valve seat possibly? Any thoughts/advice or previous experances pike this would be really appreciated.

Thanks

Chris : )

[Dudleydaftdog]

Thanks so much for all your help all. Have skimmed the shim by 0.10mm to put it back in the middle of the spec range. Wishing I'd used supertech valve seats now instead of OEM as the JUN springs/valves and tap happy cams must have put a lot of pressure on the valve seats. Highest my egt's reach is 1050f. Might try advancing my cams to run a bit cooler.

I used a Cosmetic 1.6mm HG, a friend of mind after the build said basically they are crap for st205s/185s because they are missing some of the coolant waterway holes (it all seemed to line up at the time ok?!? - St185 block with st205 heat and hg).. Is this true? Maybe to blame for the valve seat wear?

Many thanks again everyone for your info/thoughts.

Chris