![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Aug 25, '08 From England Currently Offline Reputation: 1 (100%) ![]() |
I was certain I started a build thread on here, but for the life of me I can not find it so forgive me if I start again and its old news.
About a year and a half ago my current GT4 failed its yearly inspection (MOT) with rusty sills, they were fixed and it subsequently passed but it set alarm bells ringing in my head that the poor things days were numbered. I decided that I would buy a shell and swap everything onto it. so I hunted for a reasonable shell to start work on. While I was looking, I had to extend my garage. I only had a single car garage so not enough space to work or store stuff. So I decided to extend my garage backwards a bit Work started. ![]() and after a few weeks, finished ;0 ![]() ![]() About the same time a shell turned up, well it was sold as a shell, but it was more or less a complete car minus the engine and gearbox. ![]() ![]() ![]() It was in good condition with no rust, even the interior was in pretty much spot on condition, not that I need much of it ![]() ![]() I set to wrok more or less straight away ![]() First job was to strip everything off the car ![]() everything went, all the looms, glass, suspension the works ![]() Next job was to remove the sound deadening material ![]() ![]() it then went outside for a thorough jet wash go get rid of all the years of crap ![]() ![]() As I was moving the battery to the inside I could remove the battery tray ![]() which I did ![]() ![]() Next up I needed to get to the bottom of the car....this was going to require some ingenuity. -------------------- |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Aug 25, '08 From England Currently Offline Reputation: 1 (100%) ![]() |
Well after getting over a rather mild winter, i have ventured back into the garage.
I have finally stripped my pride and joy down to a bare shel and it has been shipped off to the great B road in the sky. After saying goodbye to it I have been trying to find space for all the parts I now have, the garage is full to the brim with car parts, plus I had to buy a small wooden shed to store more stuff in....so the garage is a bit of a mess. i manged to clear myself a small patch of surface to resume work on. First off was the clutch master cylinder, i know its only small and probably not of much interest but its a step in the right direction. I could have done with sending the shaft away to get zinc plated as I am not happy with its finish, but i guess as it will never be seen it will have to do. ![]() I have replaced the insides with a brand new piston and seals. Painted the body black and cleaned up the reservoir. Then i made a start on the brake master cylinder and vacuum cylinder. it was a bit rusty so after a soak in Bilt Hamber Deox C rust remover and a quick wire brushing I have primered it and this is where I could do with your help....... Baring in mind everything in the car will be either black, silver or the colour of the car, what colour shall i paint the vacuum housing? as i want to paint the cylinder black to match the clutch master cylinder I was thinking about painting it the same colour as the car so that there is a bit of contrast...or should I go with standard black? Currently primered and waiting for me to make my mind up....excuse the mess. ![]() coming to the US in a couple of weeks for a few weeks, any car meets in florida from the 6th april? Going to Disney for my honeymoon ![]() cheers all Nial This post has been edited by Nial: Mar 23, 2014 - 1:29 PM -------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: August 18th, 2024 - 9:49 PM |