Fixing headlight tabs Options

[GotToyota]

I plan on taking off my front bumper tomorrow to fix my headlight tabs, as they're broken. What do you guys recommend using to fix the tabs?

I would like to avoid spending a lot of money to get new headlights.

-Matt

This post has been edited by GotToyota: May 19, 2008 - 11:21 PM

[illneversellmyce...]

ive used a sodering iron before to melt the plastic and spread the metled plastic across the gaps to fill them in. once the plastic cools it becomes hard again. It takes touch cuz you dont want to melt away too much ya know. Also the type of break determines the outcome. Ive done this to two lights and they ahve held strong for 3 years. this is the cheap way, d-man way is the better way to do it

This post has been edited by illneversellmycelli: May 20, 2008 - 9:09 AM

[Special_Edy]

ive used a sodering iron before to melt the plastic and spread the metled plastic across the gaps to fill them in. once the plastic cools it becomes hard again. It takes touch cuz you dont want to melt away too much ya know. Also the type of break determines the outcome. Ive done this to two lights and they ahve held strong for 3 years. this is the cheap way, d-man way is the better way to do it

+1 on this.
Yesterday I used a butane blow torch to reweld all the tabs and stud brackets back onto a Lincoln Towncar grill. Worked like a charm. If you can find some scrap ABS material (automotive grade plastic), you can use this to add material for better effect.

Clean and lightly sand the surrounding plastic on the area you wish to weld, and keep the heat low if possible. You want to melt the plastic and burn it as little as possible. You can use a pick, screwdriver, pliers or other instrument to try to mix the two pools of molten plastic together at the point of contact for a better bond, but if the surfaces are sufficiently clean they should blend together nicely.

I highly recommend adding material since the weld will otherwise not have the same strength as the original intact piece did before fracturing.

This post has been edited by Special_Edy: May 23, 2014 - 4:51 PM