6G Celicas Forums

Welcome Guest ( Log In | Register )

> put in new cv axle and now steering wheel shakes, well front end shakes
post May 24, 2014 - 1:16 AM
+Quote Post
cwong

Enthusiast
*
Joined Jun 8, '13
From goldsboro, NC
Currently Offline

Reputation: 0 (0%)




Bought new cv axle from o Riley. Not remanufactured. Had a guy put it in for 50 in a local garage. On the way home I noticed the car vibrates on steering wheel very strong when around 60mph. Also road noise has gone up. On the way home she started to pull right strongly.

So did I get a dud or did the guy put it in wrong?

 
Start new topic
Replies
post May 24, 2014 - 3:14 AM
+Quote Post
njccmd2002



Enthusiast
*****
Joined Mar 15, '07
From Tennessee
Currently Offline

Reputation: 52 (100%)




well, im guessing when the axel was installed, they probably disconnected the knuckle to lower arm or knuckle to strut. that in itself can throw the alignment off.

however, a bad balanced axel can do this, unless they busted your wheal bearing when removing the old axle. because some axles get seized and seen some people hammer them off. i would take it to the alignment shop... they can tell you if its the suspension, if not, then the axle could be.


--------------------
Learned a lot in 10 years... I hardly log in anymore, last login Today Sept 6 2019, and I was forced just to clarify a post. LOL

If you PM me and I dont respond, dont fret or cry. Im alive, better post your questions in the thread below, maybe I log back in

2grfe Swapped... Why I chose the 2GR, before you ask read here...

A great civilization is not conquered from without until it has destroyed itself from within.


@llamaraxing in Instagram is the best way to find me. I hardly log here anymore.

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: April 22nd, 2025 - 8:15 PM