DIY: install factory cruise control in a non cruise equiped car, everything u need to know! lots of pics Options

[Ryouxrs]

well i finally got it done, what is needed for this project are these parts. cruise contol actuator(under hood, and behind gas pedal) wiring harness, brake pedal switch, cruise control computer (CCM), cruise control steering wheel switch and switch cover, SRS clock ring (located behind steering wheel), combination meter with cruise light bulb ( or make your own like i did) well thats all the parts, its not a very expensive job, i maybe spent 75 dollars total on this swap. but it is VERY time consuming. lots of fun stuff to wire in, well here goes nothing... first off install all the little bits and pieces of the system, dnt worry about the wiring just yet. get all the hard part mounted up. once thats all done the fun begins, start by removing the lower drivers dash, glove box, center consoule, water fall trim, and the instrument cluster. (remove the steering wheel if you havnt already installed your new clock ring and cruise switch. the removal and instalation is pretty straight forweard for those parts. all u will need is a short and standard length philips screw driver, and a 10 & 12 mm socket and ratchet. first part of the wiring is the actuator in the engine bay, the wires run under the rad. support to the drivers side inner fender, then into the grommet on the firewall inside the drivers fender, the next step is to drill the mounting holes for the gas pedal actuator, using a 9/32 drill bit, dril the 2 mounting holes in the center of the tar paper punch outs. MAKE SURE TO DRILL SHALLOW!!! one of the mounting holes goes right behind your brake proportioning valve. then using the origional bolts, mount the actuator. then your off to that crazy looking wiring harness. all of the wiring notes, and locations are listed in the pictures below, as well as the toyota diagram for the cruise system. enjoy, and happy cruisin!

sry for the stupidly small print, download the image and blow it up to see writen txt














































PDF file from toyota service manual: please e-mail me with a request for this file, and i will reply back with the requested information.

This post has been edited by Ryouxrs: Jul 12, 2009 - 7:15 PM

[Ryouxrs]

The pigtail njccmd2002 is talking about should be behind the bolster on the right hand side of the glove box as you face it. It is a very large green connector. You can see an example of it on page one of this thread.

This post has been edited by Ryouxrs: Sep 1, 2014 - 10:11 AM