6G Celicas Forums

Welcome Guest ( Log In | Register )

> Spring Coil Bind, also known as spring sag
post Jan 13, 2015 - 2:57 PM
+Quote Post
BonzaiCelica



Enthusiast
*****
Joined Apr 24, '08
From Orange County, CA
Currently Offline

Reputation: 33 (100%)




So i purchased these TRD front Springs 48131-ST001(@ 4.1kg spring rate) for my superstrut conversion. So i didnt see rust when i bought them until i received them. So now that i've learned about coil bind/sagging from sport springs. You wouldn't think it would happen to good quality TRD Springs. pics as follow. so basically what can i do? i've read from an Subaru Forum that you can definetly tell if the springs are bad unless you get the manufacture specs of the distance between each coil. I've read that EIBACH and TRD springs are one in the same, is this true?? the length of TRD spring measure in @ 24.5 cm and claim a 1 inch drop and Stock ST205 springs are 30.5cm @ 2.5kg spring rate.













This post has been edited by BonzaiCelica: Jan 14, 2015 - 10:46 PM


--------------------
Group buy to replicate Narrow E series transaxle parts

http://www.6gc.net/forums/index.php?showto...p;#entry1107514
 
Start new topic
Replies
post Jan 16, 2015 - 4:52 PM
+Quote Post
Rusty



Moderator
*****
Joined Nov 5, '07
From New Zealand
Currently Offline

Reputation: 3 (100%)




I went off part numbers, and then did fresh acaluation, and rounded the last number up too much, though your ST205 springs spring rate are a bit low still see my thread


--------------------

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: November 29th, 2024 - 11:22 AM