What the Tuck, Wire Tucking the RC Options

[Defgeph]

Hey guys,
So I decided to start tucking my engine bay.
I didn't expect to go as far as I am now, but once I started hiding things, I wanted to hide more & more stuff. I'm not going to the extreme like coomer did, just wanted to clean up the motor a bit.


Engine before I started the tuck, it was neat, but I wanted to venture further.


I started with the passenger side, because its the easiest.
I had to remove the fenders, front bumper, and eventually the hood.



I will get better pics tomorrow, my camera ran out of battery.
Here is a blurry cellphone pic of the frame rail tucked.



I'm happy with the results, then the wiring to the alt and O2 sensor started to annoy me. lol
So I jumped in on the drivers side


Here is some of the tuck and the relocated fuse box


I can't believe how time consuming this is. I have the engine harness out of the car now, I will rewire the entire harness so I can completely hide it.

Blurry pic warning, its getting there.




I still have a ton of work to do on it, consider that the almost half way point, still plenty of things to hide and relocate. I have a feeling I'm gonna pull the engine
I will get some better pics tomorrow.

Any suggestions ?

DEF

[Defgeph]

To be completely honest Manny. I'm trying to get this thing up to CSP. I want to have some fun again.

I have the starter wired up already, not sure if its correct, but I believe I didn't mix those wires. I have 3 wires left at EA1, and three wires at the other end of the harness. Like you said one is for the alternator. The other two I don't know, colors are different on both ends.

I'll hold off on shipping the whole harness for now, I think it will run with this harness, just a matter of putting the puzzle together correctly