3S-GE Beams Clutch Questions Options

[G4Frost]

I have a 3SGE Beams in my SS-III that I presume has the stock JDM clutch in it

My clutch feels like its on its last legs its not slipping in everyday use but if I do put my foot down it doesn't slip but it does stink like burnt clutch sometimes and it releases and grabs right at the very top of the clutch pedal pedal. So what I was wondering if when I do have to replace it if you have any recommendations of what clutch kit to get (as long as it can take a hammering) and whether you think its possible to do in the garage myself or if I should take it into a shop.

and if it is worth getting a clutch kit with a new flywheel and the whole shibang or just get a stock clutch disc and if there are any guides on how to do it as I have never replaced a clutch before.

[Jmk91]

Torque wrench is your best friend. Impact snaps older rusty bolts eve nc whenever you are loosing them. I suggest tightening every bolt back to spec or around there. I wouldn't use an impact on anything haha. Just use one to remove my wheels or strut bolts.

This post has been edited by Jmk91: Jan 19, 2016 - 4:41 PM

[G4Frost]

Torque wrench is your best friend. Impact snaps older rusty bolts eve nc whenever you are loosing them. I suggest tightening every bolt back to spec or around there. I wouldn't use an impact on anything haha. Just use one to remove my wheels or strut bolts.

I dont use the impact to take off any non wheel bolts I was just using it as a reference to it being the really only speciality tool I have. I am going down to super cheap today to go pick up a 1/4" torque wrench and probably have to get a 1/2" one aswell.