6G Celicas Forums

Welcome Guest ( Log In | Register )

> engine/transmission shuddering badly on 1st gear, Not sure if clutch or transmission mounts
post Nov 16, 2016 - 6:16 PM
+Quote Post
HectortheRican



Enthusiast
*****
Joined Dec 26, '09
From Albuquerque, NM
Currently Offline

Reputation: 19 (100%)




So this has been going on for a little while to a small degree, but it recently got pretty bad after a short road trip in the car. First gear on flat pavement and downhill is generally ok, but I'm getting very bad shudders when disengaging the clutch and applying throttle when going uphill. It sometimes happens on a flat, but it's easier to modulate the clutch pedal to avoid the shudders in that situation.

Any ideas what it could be? I have a hard time believing the clutch is slipping because I don't smell burnt clutch (30,000 miles since summer 2012). Perhaps worn transmission mounts? I'll have to get under the car and visually inspect. I did a gear oil flush back in February with Pennzoil Synchromesh, but I haven't checked the levels since the shuddering began. These are the few scenarios I'm thinking of.

This does not happen in any other gear - not even reverse while backing up a hill. Only in 1st gear.

This post has been edited by HectortheRican: Nov 16, 2016 - 6:21 PM


--------------------
taking too long to mod since '09
June '12 COTM
'95 AT200
 
Start new topic
Replies
post Nov 16, 2016 - 8:48 PM
+Quote Post
HectortheRican



Enthusiast
*****
Joined Dec 26, '09
From Albuquerque, NM
Currently Offline

Reputation: 19 (100%)




Thanks guys, I will look into this.
I just tried to fill the transmission with oil and only got less than 1/4 quart until it started spilling out.

Right now, I'm having to start at about 2k to keep from shuddering too much.

I'm I'm Denver right now, so if it's the transmission mount, I think it should hold fine until I get back to ABQ. The engine is otherwise smooth in all other gears and cruising at 60-80mph on the highway.

Are there any aftermarket mounts you suggest? Or OEM? I'd love poly mounts, but they don't make AT200 mounts, to my knowledge.

This post has been edited by HectortheRican: Nov 16, 2016 - 8:51 PM


--------------------
taking too long to mod since '09
June '12 COTM
'95 AT200

Posts in this topic


Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: January 10th, 2025 - 8:55 AM