Need help Options

[Tmiller]

Hello I've mad tons of post about my Celica 3sgte gen 4 swap, I finally put it all together and started it in almost done . Unfortunately when I put my axles in and everything else and went to put it into gear the clutch isn't disengaging and letting the car move the slave cylinder and master cylinder is fine I think it's the pressure plate or clutch disk I did buy used .. can someone home me figure out how to tell if it's bad ? Like the pressure plate or clutch disk ? And I kinda was thinking I put the disk in backwards I mean is that possible?? Please help

[HardHead93]

Hello I've mad tons of post about my Celica 3sgte gen 4 swap, I finally put it all together and started it in almost done . Unfortunately when I put my axles in and everything else and went to put it into gear the clutch isn't disengaging and letting the car move the slave cylinder and master cylinder is fine I think it's the pressure plate or clutch disk I did buy used .. can someone home me figure out how to tell if it's bad ? Like the pressure plate or clutch disk ? And I kinda was thinking I put the disk in backwards I mean is that possible?? Please help

What do you mean you clutch is not disengaging? Is you clutch pedal sticking to the floor? If you can lift the pedal with your hand then there is nothing wrong, you just need to bleed you clutch because there is air in your lines. There are plenty of videos out there on how to do that.