HighOSilver 2.0 Options

[ClevelandGaint]

Finally its time to make the almighty build thread for HighOSilver. This car has been apart of the community since 2005. The original owners profile http://www.6gc.net/celicas/1994-gt-hatchback-4796. It was passed around from 2011-2017. During that time, alot of hands have been in the pot as some would say. Then my very good friend Rob, aka Sandusky1977 rescued it earlier this year. Funny story behind him purchasing the vehicle was that we were both gunning for this car at the same time, except he got there a day earlier than I could of. After he told me he purchased it, I wasn't as mad. Since we both were saying to each other that we had a awesome buy on the way but never said what it was until the purchase was made. But we had an agreement that if he was to sell it I would have first dibs on it. As we all know, he then purchased a built 2nd gen 3sgte and HighO was going to be mine. Enough the cheesy intro on how I got the car, now onto what it has:

Peformance
Gen 3 3S-GTE
E153 Transmission
Precision FMIC
Greddy Type S BOV
3" XS Power Downpipe
Custom made Exhuast
Borla ProXS #40359 3" Stainless Steel muffler

Suspension
Techniques Lowering Springs

Exterior
JDM Tails
Euro Spec Post face front bumper (soon to be install)
Sideskirts
Toms Lip (soon to be installed)

Interior
Alpine CDA-7995 Head Unit (getting replaced with a pioneer 4400bh)
MB Quart Component Set (getting replaced with infinity kappas)
Alpine MRV-450 Amp
Kicker 12" Solobaric in Custom Box Built in trunk area
Autometer Boost Gauge (soon to be upgraded)
Autometer A/F Gauge soon to be upgraded)


First day home from the drive from Michigan

[BonzaiCelica]

meh if it was up too me id get the Tanabe GF210 springs. i wish i would of got them over my current df210 springs.

tein rear kg rates are the same as stock springs... the fronts are super hard.