Safari Rally inspired build, tall and off road capable 6G - GT Options

[Roodwerks]

I haven't ironed out all the plans, most project cars are open to constant change right. I will be converting this very cheap, high mileage car into another dual sport toy. If you dig around on the internet, you can find my other two Toyotas, 1984 Expedition Celica ( https://www.youtube.com/watch?v=PSNS9-qponY&t=16s ) and 1993 Lexus SC400 RX. This time around, pulling from my favorite sport of rallying, and favorite event, East African Safari Rally for all my inspiration, with maybe a little bit of Dakar thrown in. I purchased the car for $700, 278K miles on the clock but with a newer head installed not too long ago. With the help of this Forum, lots of research from various sources and encouragement from friends, the project is off to a good start. The red wheels, just not my style and 17" rims aren't going to cut it in the dirt...

Current work finished:
-Maintenance on fuel and ignition system
-debugged wiring to clean up the engine bay and get the cooling fans working properly
-built custom SS header with race CAT and 2-1/2" dump pipe (to pass emissions)
-tossed original struts and cut springs
-installed 1997 Avalon struts and springs for travel and lift (rears are bolt on, front not really at all, used Rav4 tops, etc..)
-2 of 4 custom engine mounts to replace broken OEM versions with Polyurethane

-Jon

[Roodwerks]

No pics, but you can find pictures of this project and a few others on my Instagram - roodwerks

I've mostly been trying to track down a rough running issue when it's warming up in colder weather. It runs fine at first start up, 1-2 minutes later it starts misfiring under acceleration, a few minutes after that, sometimes up to 15 minutes later it will start running fine..? It's a weird issue with NO CEL at all. It's been doing it for a few months.

I did buy and mount a new set of center LED flood lights on the front pod, about 3 times brighter than the first pair. I've also been gathering pieces to build a custom rear subframe and arms to fix the lifted geometry and make room for a possible future rear diff..

20181104_114447 by Jon Rood, on Flickr

20181104_114034 by Jon Rood, on Flickr



This post has been edited by Roodwerks: Feb 27, 2019 - 3:58 PM