Safari Rally inspired build, tall and off road capable 6G - GT Options

[Roodwerks]

I haven't ironed out all the plans, most project cars are open to constant change right. I will be converting this very cheap, high mileage car into another dual sport toy. If you dig around on the internet, you can find my other two Toyotas, 1984 Expedition Celica ( https://www.youtube.com/watch?v=PSNS9-qponY&t=16s ) and 1993 Lexus SC400 RX. This time around, pulling from my favorite sport of rallying, and favorite event, East African Safari Rally for all my inspiration, with maybe a little bit of Dakar thrown in. I purchased the car for $700, 278K miles on the clock but with a newer head installed not too long ago. With the help of this Forum, lots of research from various sources and encouragement from friends, the project is off to a good start. The red wheels, just not my style and 17" rims aren't going to cut it in the dirt...

Current work finished:
-Maintenance on fuel and ignition system
-debugged wiring to clean up the engine bay and get the cooling fans working properly
-built custom SS header with race CAT and 2-1/2" dump pipe (to pass emissions)
-tossed original struts and cut springs
-installed 1997 Avalon struts and springs for travel and lift (rears are bolt on, front not really at all, used Rav4 tops, etc..)
-2 of 4 custom engine mounts to replace broken OEM versions with Polyurethane

-Jon

[richee3]

Might be a dumb question but have you checked the throttle cable? It may need adjustment or it might have a slight burr on the cable. It’s been forever since I’ve had a 5S but I believe there’s an adjustment screw on the throttle body as well, although I think I remember that being addressed already.

[Roodwerks]

Might be a dumb question but have you checked the throttle cable? It may need adjustment or it might have a slight burr on the cable. It’s been forever since I’ve had a 5S but I believe there’s an adjustment screw on the throttle body as well, although I think I remember that being addressed already.

No dumb questions in my book. But, yes, the throttle cable is adjusted, if anyting, a bit too loose. The only adjustment screw is the butterfly stop screw, which is properly adjusted, the plate couldn't get any more closed.